1) corner shear drop
直角压陷
2) spur gear with 28 degree pressure angle
28°压力角直齿轮
1.
Stress analysis for involute spur gear with 28 degree pressure angle;
渐开线28°压力角直齿轮应力分析
3) extruder with side delivery head
直角(机头)压出机
4) hydraulic right angle injection moulder
液压直角注模机
5) Compressed mark
压陷
6) Right-angle Three-cylinder Hydraulic Platform
直角三缸液压摇摆台
1.
Under laboratorial environment , Right-angle Three- cylinder Hydraulic Platform is a empirical equipment that simulates vibration warship and movement of the warship on the water surface, it can accomplish carrier plane illuminated guidance performance test of the system.
直角三缸液压摇摆台是在实验室环境下模拟舰船在水中的摇摆和运动的一种实验设备,可以在实验室完成舰船上舰载飞机灯光导引系统的性能实验。
补充资料:压力角
在平面连杆机构中不计摩擦和构件的惯性的情况下,机构运动时从动件所受的驱动力的方向线与该力作用点的速度方向线之间的夹角。在曲柄摇杆机构中(图1),主动件通过连杆作用在摇杆上的力P沿BC方向,力作用点C 的速度vC的方向垂直CD,这两方向线所夹的角 α为压力角。压力角α越大,P在vC方向能作功的有效分力就越小,传动越困难。压力角的余角γ 称为传动角。机构的压力角或传动角是评价机构动力学指标之一,设计机构时应限制其最大压力角或最小传动角。对于齿轮传动(图2),压力角 α也是从动轮齿上所受驱动力P的方向线与P力作用点C 的速度vC方向线之间的夹角α,压力角α的大小随着轮齿啮合位置的不同而变化。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条