1) voltage center
电压中心
2) voltage of oscillation center
振荡中心电压
1.
Based on the changing track of the voltage of oscillation center, this device can distinguish accelerating out of step from decelerating out of step, and it can adapt to the change of system network and system operating mode.
通过对电力系统异步运行状态的分析 ,提出了利用振荡中心电压的变化特征来判断系统失步的失步解列装置。
3) high-tension distribution center
高压配电中心
4) Center of pressure
压力中心
1.
Result:Using this system,the ground reaction forces in three directions during walking and the trace of center of pressure(COP) oscillation during standing on the platform can be detected.
结果:利用该系统不仅可以检测行走过程中三个方向的地面反力,而且可以检测站立时压力中心曲线,计算其动摇长度、面积等特征值。
2.
In order to exactly evaluate the walking stability and stability margin of a quadruped robot a general criteria is proposed adopting the minimal distance from the supporting edge to the center of pressure on ground to estimate the walking stability of the robot.
为了准确评定足式机器人的行走稳定性及稳定裕度,提出了采用支撑面压力中心至机器人各足支撑点构成的支撑多边型各边的最短距离来评定机器人的行走稳定性的一般准则。
3.
With the measurement and analysis of the Rs-scan plantar pressure and the JVC-9800 digital vidicon,the characteristics of plantar pressure of 6 elite track and field athletes in the final throwing phase was described from the aspects of the curve of pressure,plantar pressure distribution and the center of pressure.
使用RSscan足底压力测量和分析软件对山东省田径队的6名优秀铅球运动进行了测量,主要从压力曲线、压力中心轨迹和脚底各区的压力时间积分几个方面描述优秀铅球运动员背向滑步推铅球时脚底压力分布特点。
5) pressure center
压力中心
1.
Calculating the pressure center of punching die using Visual Basic;
用Visual Basic确定冲裁模压力中心
2.
The method to determine the pressure center based on UGII software;
用UGII软件求解冲模压力中心的新方法
3.
Determining Pressure Center for Multiple Blanking Die Based on 3D Die Design Software;
基于模具三维造型软件的复合冲裁模压力中心的确定
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条