1) slow cooling
缓冷[却]
2) slow cooling
缓慢冷却
1.
The improved slow cooling method includes two steps.
采用现有文献使用的充氮快速冷却的方式,导致钎焊接头产生了较多的裂纹和孔洞,使得强度降低;采用改进的缓慢冷却方式,即从钎焊温度到620℃,让其自由冷却,当炉中温度降到620℃时,向炉内充氮气并同时启动风机快速冷却。
2.
The over-equilibrium amount of ferrite can be obtained by deformation and subsequently slow cooling among the above mentioned temperature range.
在此温度区间形变后缓慢冷却,能够得到超平衡数量(共析转变温度的铁素体转变量)的铁素体,并且随形变温度的降低和形变量的增大,铁素体晶粒明显细化和等轴化。
3) slow,cooling zone
缓慢冷却带
4) coolant corrosion inhibitor
冷却系统缓蚀剂
1.
some question and studying development of coolant corrosion inhibitor on ship diesel engine cooling system are summarized,according to my studying experience in this field,future studying direction is suggested.
本文总结了国内外船舶柴油机冷却系统缓蚀剂存在的问题和国内缓蚀剂研究和发展的情况,结合自己在缓蚀剂研究中的经验,提出了缓蚀剂研究的思路和未来发展方向。
5) cooling
[英]['ku:liŋ] [美]['kulɪŋ]
冷却
1.
Improvement of CO_2 Recycling and Cooling System;
CO_2回收冷却系统的改进
2.
A new cooling process for soft contact electromagnetic confinement and directional solidification of special alloys;
特种合金电磁软接触定向凝固冷却新工艺
6) coolant
[英]['ku:lənt] [美]['kulənt]
冷却
1.
Roll and technique coolant lubrication for cold tandem rolling;
冷连轧轧辊及工艺冷却润滑
2.
The convection heat transfer coefficient of coolant within the grinding zone has been estimated using hydrodynamic and thermal modeling.
磨削区冷却液的热对流系数已由流体动力学和传热学模型估算得到。
3.
The methods and theories of cooling and lubrication with gas jet in metal cutting are discussed, and the present status of study on the green cutting technologies, in which the gas, such as air, nitrogen, carbon dioxide, water vapor and so on, is employed as coolant and lubricant,is introduced.
论述了金属切削加工过程中采用气体射流冷却润滑的方法和理论基础,介绍了用空气、氮气、二氧化碳气及水蒸汽等气体作冷却润滑剂的绿色切削技术的研究现状。
补充资料：缓慢
不迅速；慢：行动～。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条