说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 组装密度,记录密度,存储密度;充填度,堆积密度,装填密度,堆砌密度
1)  packing density
组装密度,记录密度,存储密度;充填度,堆积密度,装填密度,堆砌密度
2)  packing density
装填密度
1.
When the carrier packing density was 30%,hydraulic retention time was 7h(inc.
在填料装填密度为30%,水力停留时间为7h(其中厌氧3h,好氧4h),pH值在6。
2.
The results obtained from the parallel comparative tests showed that when the carrier packing density is 30~0_0, hydraulic raction time is 10 hours (including 3 hours for anaerobic zone and 7 hours for aerobic zone), influent pH is 6.
采用平行对比试验,试验结果表明:系统在填料装填密度为3000,反应时间为10h(其中厌氧3h,好氧7h),pH值在6。
3)  loading density
装填密度
1.
The effects of the mode of press-molding of RDX on the initiation strength of detonators are studied by system analysis of data of resulting charge loading density and density gradient.
该文从药柱装填密度、密度梯度等方面进行分析,讨论了黑索今压药方式对雷管起爆威力的影响,建议采用定压压药方式压制黑索今药柱。
2.
Theoretical and experimental analysis under the conditions of various loading density,propellant,constant volume and variational volume are made.
为了研究火药实际能量的释放规律,通过对几何燃烧模型的分析和修正,建立了相对压力冲量形式的修正模型,并在不同装填密度、不同类型的火药和定容、变容条件下进行了理论和实验分析。
4)  packing density
填充密度
1.
Effect of packing density of hollow fiber contactors on shell-side mass transfer in distillation
填充密度对中空纤维膜接触器精馏过程壳程传质的影响
2.
In literature,the conclusions about the effect of packing density on mass transfer coefficient are inconsistent, which probably is due to the ignored effect of module wall and hollow fiber interaction.
通过数值模拟研究了纤维管填充密度 ( 2 7 18%~ 6 7 11% )增加时传质系数的变化趋势 ,同时考察了流体速度对传质系数的影响 。
3.
In this paper, on the basis of analyzing the complex swing characteri sties of the points on the plane of moving jaw, the reasonable mobile state of the crushing stone in crushing chamber are defined, and the methods for analyzing and computing the falling height of the each crushing layer and its packing density are presented.
本文在动腭齿面复杂摆动特性定量分析基础上,分析确定了物料在破碎腔内的合理流动状态,提出了腔内各物料层一次落料高度以及相应填充密度的分析和计算方法。
5)  packed density
填充密度
1.
By analyzing the volume mass-transfer coefficient,the optimal operating flow-ratio and packed density were obtained.
通过考察体积传质系数,确定了纤维液膜萃取分离器的最佳填充密度和最佳流量比。
6)  filling density
充填密度
补充资料:非密度制约因素(见密度制约因素)


非密度制约因素(见密度制约因素)


  l焦非密度制约因素见生态因素、密度制约后
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条