1) motive steam generator
驱动蒸汽发生器
2) steam generator
蒸汽发生器
1.
Study on the water feed transient accident of the steam generator;
蒸汽发生器给水瞬变事故的研究
2.
Electron metallographic analysis of cracks of steam generator tubes;
蒸汽发生器传热管裂纹断口电子金相分析
3.
Seal Retrofit of Oil Steam Generators;
油浆蒸汽发生器的密封改造
3) SG
蒸汽发生器
1.
ALARA ACTIONS DURING INSTALLATION/REMOVAL OF NOZZLE DAMS IN PRIMARY WATER CHAMBER OF SG;
蒸汽发生器装拆堵板的辐射防护最优化
2.
On the Stress Corrosion Cracking of Heat Transfer Tubes of SGs;
关于蒸汽发生器传热管应力腐蚀的几个问题
3.
This paper presents the principle of SG level fuzzy control system, and describes the hardware design and software design of SG level s semi-physical FUZZY-I simulation system.
介绍了蒸汽发生器水位模糊控制原理 ,着重讨论了蒸汽发生器水位FUZZY -I控制半实物仿真试验系统的硬件设计和软件设计。
4) motive steam condenser
驱动蒸汽冷凝器
5) flash steam generator
闪蒸蒸汽发生器
6) nuclear steam generator
核动力蒸汽发生器
1.
The nuclear steam generator is a high complex,large time delay,non-linear,and time vary system.
针对传统的核动力蒸汽发生器水位PID控制方法存在的缺点,将神经网络方法与PID控制的结构结合起来,提出核动力蒸汽发生器水位单神经元自校正PID控制方法,在线调整控制器参数。
2.
The simulation model of dynamics characteristic for nuclear steam generator (SG) water level process based on Matlab was built by using mathematical model of nuclear steam generator and simulation tools in Matlab/Simulink environment.
利用核动力蒸汽发生器(SG)的数学模型和Mathlab的Simulink仿真工具建立了SG水位动力学特性的仿真模型。
3.
The simulation model of dynamics characteristic for nuclear steam generator (SG) water level process based on Matlab is built by using mathematical model of SG and simulation tools in Matlab/Simulink environrhent.
利用核动力蒸汽发生器(SG)的数学模型和Mathlab的simulink仿真工具建立了SG水位动力学特性的仿真模型。
补充资料：蒸汽发生器
利用各种能源产生的热量将水转变为蒸汽的换热设备。它是蒸汽动力装置的主要设备之一。也有极少数的蒸汽发生器产生其他工质的蒸汽。习惯上，蒸汽发生器是指大容量的蒸汽锅炉（主要是大型电站锅炉），也可能是核动力装置、太阳能动力装置、地热动力装置或海水温差动力装置中产生蒸汽的设备。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条