1) impulse fuse
冲击熔丝
2) shock melting
冲击熔化
1.
The results indicate that the shock melting of the porous iron occurs in the pressure range of 121 to 157GPa.
研究结果表明 ,该多孔铁材料的冲击熔化压力范围在 12 2～ 157GPa之间 ,利用多孔铁可以测得铁在 2 0 0GPa压力内的冲击熔化温度。
2.
In this paper,we make use of the experimental results of shock melting of Al,Cu,Pb and take account of the transition of Grüneisen coefficients γ(ρ) from solid state value to liquid state value,and thus provide the scaling of melting curve T m( ρ .
利用Al、Cu、Pb的冲击熔化实验结果 ,并考虑到材料的Gr櫣ｎｅｉｓｅｎ系数γ(ρ)从固态值向液态值过渡 ,通过Lindemann熔化定律标定了熔化曲线Tm(ρ)。
3) Impact tapping
冲击攻丝
1.
Application of PU Elastomer as Cushion in Impact Tapping System;
聚氨酯弹性体在冲击攻丝中的缓冲应用
2.
Impact tapping, as a novel technology of internal thread processing ,has some important effect and a good applied foreground in the machining of small diameter thread ,especially for thin board .
冲击攻丝作为一种新型的内螺纹加工技术,在解决小直径薄板内螺纹加工方面发挥着重要的作用,并具有良好的应用前景。
3.
The article discussed one kind of newest thread processing method-impact tapping,studied the method of transferring energy.
讨论了一种最新的螺纹加工方法—冲击攻丝,研究了冲击攻丝装置的能量传递方法,运用应力波理论讨论了冲击构件中两物体碰撞界面处反弹系数,应用应力波在界面处的反射、透射的波动理论,近似得出两物体碰撞后的反弹系数。
4) expulsion gap
与冲击熔丝串接的灭弧间隙
5) shock induced melting point
冲击熔化点
6) shock-induced melting region
冲击熔化区
1.
The material strength in shock-induced melting region was analyzed with renormalization group theory,and it indicates that the material strength begin to decrease as soon as the melting mass fraction reaches 0.
采用重整化理论对材料在冲击熔化区的强度进行了分析,结果表明,在冲击熔化区内,材料的强度在熔化质量分数达到0。
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条