1) heat level
温度，热度
2) Heating Temperature
加热温度
1.
Experimental research on heating temperature of hot-reclamation of used resinbonded sands;
树脂旧砂热法再生加热温度的研究
2.
Effect of the heating temperature and heat retaining time on the inner crack healing in steel;
加热温度及保温时间对结构钢内部裂纹愈合的影响
3.
With the increasing of heating temperature,TiO2 film formed on pure titanium surface;the oxidation weight gain increased.
结果表明,在300~1100℃,随着加热温度的升高,纯钛氧化加重,形成氧化钛膜;300~500℃,纯钛试样增重0。
3) dry heat temperature
干热温度
4) moisture heat temperature
湿热温度
5) adiabatic temperature
绝热温度
1.
Calculation of adiabatic temperature and study on knietics of preparation of amorphous boron powder by heating reduction with magnesium;
镁热还原法制备无定形硼粉绝热温度的计算与动力学研究
2.
A programm was developed to calculate the adiabatic temperature of NiTi reaction,and the relation between adiabatic temperature and NiTi content,preheating temperature.
根据热力学原理编程计算了NiTi反应时的绝热温度及其与稀释剂w(NiTi)含量和预热温度的关系。
3.
The adiabatic temperature(Tad) and reaction heat per unit mass in NH4VO3-TiO2-Cr2O3-Ni-Al reaction system was calculated to be 1 889.
计算知NH4VO3-TiO2-Cr2O3-Ni-Al反应体系的绝热温度(Tad)为1 889。
6) pyrolysis temperature
热解温度
1.
Effect of pyrolysis temperature on pyrolysate during fast pyrolysis of industrial lignin made by acid precipitation;
热解温度对酸沉淀工业木质素快速热解液体产物的影响
2.
By controlling only pyrolysis temperature of Fe(CO)5, polycrystalline iron fibers with tunable structure and chemical compositions were prepared by carrier gas flow induced method.
仅通过控制Fe(CO)5的热解温度(Td),用气流诱导法制备了化学组成与结构可控的多晶铁纤维。
3.
The change of final pyrolysis temperature,characteristic of waste,rate of gas yield and the key element of gas calorific value were studied in detail.
结果表明:实用热解设备的产气率高,理想热解温度在700℃以下。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条