1) centrifugal water-packed gland
离心水封
2) centrifugal seal
离心密封
3) hermetic centrifuge
密封离心机
4) centrifugal dewatering
离心脱水
1.
The best coagulation conditions of scum from waterworks were researched by centrifugal dewatering experiments with cationic polyacrylamide(PAM),anionic PAM,non-ionic PAM and polydimethyl diallyl ammonium chloride(HCA).
针对给水气浮浮渣,选用阳离子型、阴离子型、非离子型聚丙烯酰胺(PAM)以及聚二甲基二烯丙基氯化铵(HCA)作絮凝剂,调理后进行离心脱水试验,研究絮凝调理的最佳条件。
2.
This paper analyzes the environmental characteristics of the hydraulic suction-centrifugal dewatering dredging process,which was applied to clean up the sediments.
以水力吸泥 -离心脱水组合疏浚工艺用于清理此种底泥的环境特征分析 ,采用现场疏浚操作时 ,同步进行相关物流与水体采样监测的方法进行 。
3.
After modification of the existing treatment process of petrochemical sludge,factors affecting the effect of centrifugal dewatering are analyzed to determine that the sludge treatment amount is 8.
独山子石化公司对原有石化污泥处理工艺进行了离心脱水技术改造,对影响离心脱水效果的因素进行了分析,确定了离心脱水法污泥处理量为8。
5) centrifugal pump
离心水泵
1.
Series connected and parallel connected centrifugal pump and their economy analyses;
离心水泵串并联及经济性
2.
In accordance with the features of mining centrifugal pump,the paper discusses a method of applying optimal theory for impeller design .
针对矿用离心水泵的设计特点，探讨了应用优化理论进行叶轮设计的方法。
6) centrifugal water pump
离心水泵
1.
Research on measures for reduction of energy consumption of centrifugal water pumps;
关于降低离心水泵能耗的研究
2.
The analyzing about cavitation corrosion phenomenon of the centrifugal water pump at the rolling mill;
轧钢厂离心水泵气蚀现象分析
3.
Based on finite element analysis of the model for high pressure centrifugal water pump system,the difference between innate and running frequencies in the system is determined.
采用有限元法对高压离心水泵系统进行模态分析,发现系统的固有频率与系统的运转频率有较大的差异,系统的动力学性能对抗震性能影响较小,因此可采用静强度分析方法分析系统的抗震性能。
补充资料：离心密封
借离心力作用使液体质点沿径向甩出，以阻止液体进入泄漏缝隙的非接触式动密封。图为离心密封的结构示意。液体为装在轴上的甩油盘所阻挡,并在离心力作用下甩到密封盖上,最后经回流孔流回箱内，达到密封目的。离心密封仅适用于液体、密封压差为零或接近于零的高速和高温场合。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条