1) resistivity correction factor (RCF)
电阻率校正因子，电阻系数校正因子
2) correction factor
校正系数，修正系数，校正因数，校正因子
3) resistivity correction
电阻率校正
1.
On the basis of stated above, two conventional methods for resistivity correction (information correction and chartboard correction) are discussed theoretically.
分析了泥浆侵入可能对电阻率造成的影响,在此基础上对常用的2种电阻率校正方法(信息校正 法和图版校正法)在理论上进行了探讨。
2.
Methods of Formation Resistivity Correction for Salty Mud Invasion;
除此以外,本文还研究了其它的一些针对盐水泥浆侵入地层的电阻率校正方法,通过编制相应的处理程序,对具体测井数据进行了处理分析,验证了这些方法的有效性和实用性。
4) corrected resistivity
校正电阻率
5) stator resistance correction
定子电阻校正
1.
A stator resistance correction method, in which the flux error between the values of estimation and instruction is used to obtain the correction coefficient of stator resistance, is proposed to eliminate the effects caused by stator resistance variation.
针对定子电阻对滑模观测器造成的影响,本文提出一种基于磁链误差的定子电阻校正方法,通过磁链观测值和给定值之间的误差得到定子电阻校正系数,从而消除由于定子电阻变化所带来的影响。
6) calibration factor
校正因子
1.
By means of experiments and theoretical calculations,the relative weight calibration factor was obtained.
通过实验和理论计算,确立了各组分的相对质量校正因子,建立了测定DMF纯度及杂质含量的校正面积归一法。
2.
A new calculation formula for the calculating relative mass calibration factor was found based on the flame ionization detector (FID).
根据FID检测器工作原理 ,提出一种相对质量校正因子的计算公式。
3.
Method : Calibration curves of both sulbactam and sulbactam penicillamine were determined by HPLC and the slope ratio of these two curves was defined as a calibration factor, which could represent the ratio of the two mole ultraviolet absorption coefficients.
方法:通过HPLC-UV法测定舒巴坦与舒巴坦青霉胺的标准曲线,以其斜率的比值表征二者的摩尔紫外吸收系数比值,并作为校正因子;在样品测定过程中,即可采用加校正因子的主成分自身对照法测定舒巴坦青霉胺杂质的含量。
补充资料：电导率(见电阻率)
电导率(见电阻率)
conductivity
d!日nd日O}已电导率(eonduetivity)见电阻率。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条