说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 射束交迭损耗
1)  beam crossover loss
射束交迭损耗
2)  AC losses
交流损耗
1.
Study of numerical simulation of CICC AC losses;
CICC导体交流损耗数字模拟研究
2.
AC losses is one of the critical issues on the development of High T c superconducting transmission cable.
介绍了高温超导输电电缆的交流损耗试验系统 ,电缆交流损耗理论模型以及 1米长高温超导输电电缆的交流损耗试验结果。
3.
This paper reported studies about the influence of ac magnetic field on ac losses of superconductors.
本文报道交流磁场对高温超导体交流损耗Q的影响。
3)  AC loss
交流损耗
1.
Calculation of AC loss for HTS transformer on EMU;
电动车组高温超导变压器交流损耗计算
2.
Numerical calculation and analysis of AC loss in high temperature superconducting tapes;
高温超导带材交流损耗的数值计算与分析
3.
Experimentally determined AC loss i n Bi2223tapes at 4.
2K和外加直流背景场条件下的交流损耗。
4)  alternate iron losses
交变损耗
5)  switch loss
交换损耗
6)  reflection loss
反射损耗
1.
The Lichtenecher formula is used to culculate the electromagnetic parameters of radar absorbing coatings which are respectively made up of some adhesive and various radar-absorbing ingredients,the reflection loss formula (RLF) applicable to the homogeneous radar absorbing coatings is deduced according to the electromagnetic theory.
本文利用Lichtenecker性能加和公式对涂层的等效电磁参数进行了模 拟计算和分析,并根据电磁理论详细推导了涂层的反射损耗与其等效电磁参 数之间的关系,建立了由胶粘剂和不同种类、不同体积分数的吸收剂组成的 多层吸波涂层的吸波模型,并通过实验验证了该吸波模型的合理性。
2.
The paper puts emphasis on via s influence on signal reflection loss, and tries to give the optimum size of the via with numerical analysis and simulation method.
本文介绍了过孔的模型,采用软件HFSS对多层印刷电路板上的过孔设计进行仿真,通过仿真的方法找到过孔尺寸对反射损耗的影响规律,从而求出最佳的过孔尺寸,仿真结果对于高速PCB电路板设计具有实际指导作用。
3.
The results show that the effect of these factors on the reflection loss are in the following order, from strong to weak, milling time, particle size and mass fraction of the absorber.
结果表明:在设计范围内,各因素对吸波材料反射损耗的影响顺序从大到小为:球磨时间、粒径和质量分数;获得的最佳工艺条件:球磨时间为15h、吸收剂粒径小于48μm及其质量分数为75%,从而实现了对吸波材料性能的优化设计。
补充资料:交流损耗(alternatingcurrent(A.C.)powerloss)
交流损耗(alternatingcurrent(A.C.)powerloss)

超导体通以交流电流或在交变磁场中,其传输电流有能量损耗并转变为热能,称交流损耗。此损耗与交变频率有关,乃至到达相当高频率时,超导体成为与正常导体一样。例如对锡,在频率高达红外区域时就与正常导体的锡几乎没有差异;但在低频下,则几乎无损耗。对处在混合态的硬超导体,其磁化曲线是不可逆的,有磁滞现象,则磁通线在交变磁场中往返运动时,需克服钉扎力和黏滞阻力作功而损耗能量并转化为热能耗散,称磁滞损耗。对处在交变电流或交变磁场中的迈斯纳态的超导体,有认为其表面并非完全光洁而有能耗,本质上也是一种磁滞损耗。另外,交变磁场感生涡旋电场,此电场使正常电子流动有欧姆损耗,称涡流损耗。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条