2) fixed assets expenditure
固定资产支出
3) fixed supporting
固定支承
1.
Has analyzed the reason for that the work piece surface has appeared periodic error while adopting fixed supporting used in centerless grinding.
研究了采用固定支承进行外圆无心磨削时,工件表面产生周期性误差的原因;分析了固定支承角的大小对定位误差的影响,按非对称性固定支承分析定位误差,提出了利用调整固定支承角的方法提高磨削加工精度的途径;阐述了这样一种方法的可能性:即在零件生产规模达到一定批量时,首先要找出零件上原始形状误差的分布规律,在此基础上,通过优化调整无心磨床支承角,使工件原始周期性形状偏差引起的周期性形状误差达到最小化。
4) fixed bracket
固定支架
1.
Combined with the producing practice,this paper introduces its working principle and process of the spot welding of wiper fixed bracket and the factors influencing the welding quality.
本文结合生产实际,阐述了刮水器固定支架点焊的原理、工作过程,以及影响焊接品质的因素,提出了该焊接的工艺参数、注意事项和实用的检验方法。
2.
The bending technology of fixed bracket for the tube of excavator was analyzed.
分析了挖掘机油管固定支架的弯曲成形工艺 ,介绍了该零件的弯曲模结构及其工作过程 ,并介绍了该模具主要零件的设计制造。
5) supporting-immodile
支载固定
6) fixed support
固定支架
1.
Importance of fixed support in heat pipe net;
浅谈固定支架在热力管网中的重要性
2.
The result shows that the scheme using ball joint compensators is feasible, which reduces the quantity of fixed supports and is easier to construct.
针对管径大于1000mm的高温热水管道穿越市区不允许开挖道路的情况,考虑3种管道设计方案,分别进行了分析,比较结果表明,采用球型补偿器的方案切实可行,不仅可以减少固定支架的数量,而且可以降低施工难度。
3.
In the design of the compensators and supports of the piping line, th e amount and the recuperability of the fixed supports should be reduced as much as possible, and the distance between any two fixed supports should be enlarged as much as possible according to the features of the piping line, from which the economic benefit of the piping line can be fully embodied.
在管系补偿器与支架的设计中,应尽可能减少固定支架的数量及固定支架的复原力,两个固定支架间距离可根据管系特点尽可能加大,将使管网经济性得到充分体现。
补充资料：固定
①不变动或不移动的（跟‘流动’相对）：～职业丨～资产。②使固定：把学习制度～下来。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条