1) isothermal bath
等温浴
2) Austempering in salt bath
盐浴等温淬火
3) isothermal quenching bath
等温淬火浴炉
4) molten lead austenitizing
铅浴等温淬火
5) low temperature salt-bath
低温盐浴
1.
The technological process of die steel H13 was inguired by low temperature salt-bath vanadium-nitrocarburizing,and microstructures,hardness,element distribution and phases of the infiltration of samples were investigated.
探讨了H13模具钢的低温盐浴氮碳钒共渗工艺,并对渗层组织、硬度、渗层中的元素分布以及物相组成等进行了研究。
6) coagulating temperature
凝胶浴温
1.
Only when the miscibility ofpolymers is better,a blended UF membrane with greatly improved flux orretention rate will be obtained by raising coagulating temperature or byadding a small amount of NaCl without excessive damage of other prope-rties.
虽然凝胶浴温提高都使膜的透水率提高而截留率下降,但相容性好可在截留率下降较小的情况下较大地提高透水率;利用少量NaCl 对凝胶浴的添加,也只有在相容性好时才能在不降低透水率的情况下有效改善截留率;蒸发时间的影响也因相容性不同而异,但延长蒸发时间并不可取。
补充资料：35CrNi3MoV钢等温淬火组织
35CrNi3MoV钢等温淬火组织
35CrNi3MoV钢等温淬火组织马氏体(绿)+见氏体(棕)残余奥氏体(浅黄)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条