2) inlet guide device
进口导卫
1.
The paper analyzed the causes of sticking iron skin on inlet guide device of wire rolling mill ,and gave the perfect method of how to remove it,in fact,the mothod has been proved to be good.
分析了线材轧机进口导卫粘挂铁皮的原因,并根据实际提出了消除方法,实践证明,采用本文所述的消除方法后,取得了良好的效果。
3) IGV
进口导叶
1.
Numerical and Experimental Investigation to Unsteady IGV-Impeller-Diffuser Interaction;
进口导叶/叶轮/扩压器非定常相干的数值与实验研究
2.
The flow field behind the inlet guide vane(IGV) of the centrifugal compressor was measured under different IGV prewhirl angle,and the influence of IGV prewhirl angle on the flow field and performance was investigated.
在不同的进口导叶预旋角度下对一单级离心压缩机级进口导叶后面的流场进行了测量,分析了进口导叶预旋角度对流动及性能的影响。
4) inlet guide vane
进口导叶
1.
A brief introduction to the variable inlet guide vanes(VIGV) of MS6001 gas turbine units compressor is being presented,with focus on the influence of 3 different VIGV openings occurring during start up and 2 different modes of on load operation on the back pressure of gas trubines.
简要介绍了MS6001燃气轮机机组压气机可调进口导叶(VIGV)的控制。
2.
The performance of the centrifugal compressor at different diffuser stagger angles and different inlet guide vane(IGV) prewhirl angles are measured.
对扩压器进口不同安装角和进口导叶不同预旋角匹配下离心压缩机的性能进行了实验研究。
3.
The flow passing the inlet guide vanes of centrifugal compressors are calculated numerically under different incidence angles and different Re Numbers, the unsteady development of the trail vortices are discussed.
本文在不同攻角和不同雷诺数Re下,对离心压气机进口导叶的内部流动进行了数值分析,探讨了导叶翼型绕流尾涡的非定常发展过程。
5) approaching buoy
进口导标
6) IGV (inlet guide van)
进口导翼
补充资料：再进口
系进出口贸易统计术语。再进口是指本国商品出口后，在国外未经加工而又重新运回国内。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条