1) hot metal
高温金属;铁水
2) high temperature molten iron
高温铁水
1.
Described are the technical requirements on the transport by track for high temperature molten iron of metallurgical enterprises, the determination of the scheme of cars for transport by track, development of thermal insulation system and securing of equipment, et al.
介绍了冶金企业高温铁水过轨运输的技术要求、过轨运输车的方案确定、保温系统的研制与设备的加固等。
3) metallic pyrometer
金属高温计
4) iron-based superalloy
铁基高温合金
1.
Under thermal cycling treatment, the chang of Vickers-Hardness(HV) and phase in iron-based superalloyis studied by TEM, et al.
借助透射电镜等手段,研究了循环加热状态下,铁基高温合金的维氏硬度变化及相交过程,结果表明,实验合金在57℃到650℃之间循环热处理,固溶处理后再经循环热处理的试样的硬度随循环次数的增加而增加;固溶处理加两次时效处理后再经热循环的试样,循环次数少于30次时,硬度随循环次数的增加而减小,循环加热次数多于30次,硬度随循环次数的增加而增加,其硬度的变化与合金中析出的有序相的尺寸及分布有关。
2.
Influences of die wall lubrication on mechanical properties of iron-based superalloy powder compacts;
研究铁基高温合金粉末模压成形致密化过程中的影响因素和作用机理。
6) Fe Ni matrix high temperature alloy
铁镍基高温合金
1.
Trace impurity elements As,Te,Sb,Pb,Sn,Bi,Ag,Tl in the Fe Ni matrix high temperature alloy are determined by HCD 1 hollow cathode discharge source with a set of K3 nickel matrix alloy standards used as calibration curve The results show that the method is fast and convenient,and possesses relative low detection limits and good accuracy and precisio
采用 Ｈ Ｃ Ｄ１ 型空心阴极光源作为发射光谱的激发光源， 以一套 Ｋ３ 镍合金基标准做工作曲线来分析铁镍基高温合金中的微量杂质元素砷， 碲， 锑， 铅， 锡， 铋， 铊和银。
补充资料：120t氧气顶吹转炉在兑铁水(首钢)
120t氧气顶吹转炉在兑铁水(首钢)
120t氧气顶吹转炉在兑铁水(首钢)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条