1) electroslag resistance furnace
电渣电阻炉
2) Electric furnace slag
电炉渣
1.
Guixi smelter finally determine the slag process according to the successful experiences of foreign slag concentrator and the flotation test of cooled electric furnace slag, after this project put into operation, may collect from the discard electric furnace slag 5000 tons of copper metal per year.
江西铜业公司贵溪冶炼厂近年来通过技术改造,形成了30万t/a的矿铜生产能力,其闪速炉渣处理方式为电炉贫化, 电炉弃渣中含铜较高,贵冶借鉴国外炉渣处理的经验并通过缓冷电炉渣的浮选试验,最终确定了电炉渣和转炉渣混选工艺流程,该项目投产后预计海年可从废弃的电炉渣回收5000t铜金属。
2.
The reasons of high copper content in electric furnace slag combined with Guixi Smelter production practice are analysed,the effective ways of reducing the copper content in electric furnace slag are put forward,it is pointed that the key to reduce the copper content lies in maintaining the circumstance of the flash furnace well and restricting the over output of magnetic Fe3O4 in slag.
结合贵溪冶炼厂的生产实践,分析了引起电炉渣含铜高的原因,提出了降低电炉渣含铜的有效途径和方法,指出了维护好闪速炉炉况和抑制渣中磁性Fe3O4过量生成是实现降低电炉渣含铜的关键。
3.
After the technical improvement,this system reaches the designed capacity and standard,reclaims 5000 t copper from the electric furnace slag,and improves the utilization of copper resource.
江西铜业集团公司贵溪冶炼厂电炉渣和转炉渣采用粗碎→半自磨→球磨→浮选的新工艺处理,通过实施技术改造,该渣选系统1年实现达产达标,从电炉渣中回收5000t铜金属,提高了铜资源综合利用率。
3) electro-titanium slag
电炉钛渣
1.
,phase compositions of electro-titanium slag were studied.
采用化学分析、X射线衍射和扫描电镜等分析方法,对电炉钛渣的相组成进行了研究,查明了钛渣主要由黑钛石固溶体、塔基石固溶体、硅酸盐玻璃体和游离的TiO2组成。
4) Electroslag furnace
电渣炉
1.
Fuzzy adaptive PID control for electrode regulating system of electroslag furnace;
电渣炉电极调节系统的模糊自适应PID控制
2.
The electric equipment of a 200t electroslag furnace;
200t大型电渣炉电气设备
3.
Abstract: This article describes three stages in the development of electroslag furnace and its recent development.
系统论述了电渣炉发展的三个阶段，以及电渣炉最新发展。
5) electric furnace slag field
电炉渣场
1.
Two trapping methods are discussed in accordance with the situation to disorderly discharge smoke and dust on electric furnace slag field and the features of the smoke and dust.
针对电炉渣场烟尘无组织排放和烟尘性质较为特殊的特点,探讨了两种渣场烟尘捕集方式。
6) electric steel furnace slag
电炉白渣
1.
Reducing and leaching retention effect of ground granulated blast-furnace slag and ground electric steel furnace slag on Cr(Ⅵ);
高炉矿渣和电炉白渣细粉对Cr(Ⅵ)的还原与溶出抑制作用
补充资料：厂用电受电
厂用电受电
energizing of auxiliary power system
chongyongd一on sho一Jd一on厂用电受电(energizing of auxiliary powersystem)机组附属设备安装完毕后需通电试运行，所需厂用电源由外部供给，因此厂用电受电是调试工作开始的标志。 受电步骤新建电厂先由电力系统向变电站供电，再依次对高压起动/备用变压器、3~10kv厂用配电装置、厂用工作变压器及380V配电装置供电。扩建电厂因高压起动/备用变压器已经投人运行，故可利用它的电源对扩建的厂用配电装置等供电。 调试项目主要有:①用额定电压依次对空载线路、变电站母线、隔离开关、断瘩器、互感器、变压器及厂用配电装置等进行冲击合闸试验。有条件时.冲击合闸前应先进行递升加压试验。升压过程中注意检查各设备有无放电声及短路现象，发现问题及时处理后再进行升压。②检查三相电压应平衡，相序应正确，各段母线的相位彼此应一致。对配电装置供电时，有时会由于母线电容和与母线连接的电磁式电压互感器的电感相互作用而出现铁磁谐振，此时相电压升高，中性点明显位移。为消除谐振可在电压互感器的剩余电压绕组处并联电阻以去振。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条