1) accelerated leaching
加速浸出
2) leaching rate
浸出速率
1.
Principle and analysis of oil leaching rate model;
油脂浸出速率数学模型的建模原理与分析
2.
The result indicated that the alumina leaching rate and temperature of reaction system both increase with microwave power, and the temperature of reaction system is not co.
研究了微波辐射加热条件下高炉铝酸钙渣的浸出过程·考察了微波辐射加热下,微波辐射功率、浸出用液的Na2OC质量浓度、液固比等对炉渣浸出反应的影响,并与传统加热浸出进行了比较·结果表明,氧化铝浸出率和反应体系的温度随着微波辐射功率的提高而增加·在温度未达到溶液沸点之前,反应体系为非恒温反应过程·微波辐射浸出与传统加热浸出相比较,微波辐射加热下炉渣中氧化铝浸出速率较传统加热方式浸出快得多,在氧化铝浸出率相同的前提下,微波浸出可降低浸出用液的Na2OC质量浓度,缩短浸出时间
3) leaching speed
浸出速度
1.
Through using reagent X pretreatment in Hetai gold concentrate cyaniding technology, cyanide leaching speed is improved, related working conditions are optimized, and cyaniding capacity increased, which reduced material consumption and treatment cost, improved enterprise economic benefit.
对河台金矿金精矿氰化工艺,通过采用药剂X预处理的方法,提高了氰化浸出速度,优化了相关作业条件,增加了氰化处理能力。
2.
Increasing the content of dissolved oxygen in cyanide pulp can quicken the gold leaching speed obviously, raise the productivity and improve leaching rate of gold without increasing leaching equipments.
提高氰化矿浆中溶解氧的含量 ,可明显地加快金的浸出速度 ,在不增加浸出设施的情况下 ,提高生产能力 ,提高金的浸出
4) pressure leaching
加压浸出
1.
Experimental investigation on pressure leaching of copper-zinc ore;
铜锌混合矿加压浸出的试验研究
2.
The pressure leaching kinetics of synthesized marmatite was studied.
以人工合成的高纯度铁闪锌矿为对象,研究了其加压浸出动力学。
3.
The experimental investigation has been conducted to seperate molybdenum from spent Mo-Co catalyst by pressure leaching.
采用加压浸出从钼钴废催化剂中分离钼,在原料摩尔比Na_2CO_3/Mo=1。
6) With acid in
加酸浸出
补充资料：氨浸出
氨浸出
ammonia leaching
o「、J Inehu氨浸出(ammonia leaehing)J下J含氨的水溶液作为浸出剂的浸出方法。氨是·种配位体，能与某些金属离子形成配合物(络合物)进入溶液。浸出过程一般通入氧作为氧化剂，氧化被浸出固体物料中的有价组分。氨浸出可在常压或加压下进行。含自然铜、氧化铜或碳酸铜的矿石，可在常压下浸出;而含铜、镍、钻、锌等硫化物精矿，则采用加压氧氨浸出，浸出温度通常为358一373K，氧气压力为0.7一1.4MPa。浸出液经蒸馏除去的氨，可用水吸收后循环使用。氨浸出的优点是能处理含铁高和含碱性脉石的矿物原料，设备的防腐问题容易解决。由于氨具有挥发性，氨浸出需要在密闭反应器内进行。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条