说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 煤气调压站
1)  regulatory station
煤气调压站
2)  gas pressuring station
煤气加压站
1.
The automation control system in the gas pressuring station was analyzed.
对煤气加压站自动控制系统进行了分析,依据现有的技术手段对其提出了改造措施,分析了煤气热值测量方法与热值控制回路组成。
2.
This paper introduces how to implement automation control in gas pressuring station of Baotou Steel with the new total digital distributed control system(DCS) JX-300X.
利用集散控制系统JX-300X实现了对包钢宽厚板混合煤气加压站的自动化控制。
3)  gas regulator station
燃气调压站
1.
Some problems, such as design scale, regulating process, regulator model selection and ways of reducing investment of gas regulator station are discussed.
探讨了燃气调压站的设计规模、调压流程、调压器选型及降低投资的途径等问题。
2.
From the field instrument process interface, electrical interface to digital interface which communicate with the dispatch center, the article proposes gas regulator station digital ideas, suggestions and examples.
文章从现场仪表的过程接口、电气接口到与调度中心通信的数字接口,提出了燃气调压站数字化的思路、数字接口的建议与示例。
4)  gas regulator
煤气调压器
5)  adding pressure station with the mixed coal gas
煤气混合加压站
1.
In this paper introduces the plan of using the PLC to adjust the pressure and heat value of adding pressure station with the mixed coal gas and developing system picture with configure software Kingview5.
 介绍了对煤气混合加压站的压力、热值调节自控系统实现方案;并利用组态软件Kingview5。
6)  gas purification and compressor station
煤气净化加压站
1.
The technologies of variable frequency regulating speed control, programmable control, and electronic surveillance are used to realize the centralized monitoring and control in gas purification and compressor station, and ensure the safe operation for full-automatic compressor pressurized gas supply and constant pressure gas supply.
采用变频调速控制、可编程序控制和电子监视技术,实现煤气净化加压站的集中监控,保证压缩机全自动加压供气、恒压供气的安全运行。
补充资料:固定床加压煤气化炉
分子式:
CAS号:

性质:又称固定床加压煤气化炉(干法排渣)。煤气化炉的一种型式。气化炉是一直立圆筒,炉顶有加煤装置,底部有炉箅,气化炉上部设有分布兼搅拌破碎装置。气化剂(水蒸气和氧气)由炉底部通过炉箅进入炉内,与炉内的块煤进行气化反应,主要反应:2C+O2=2CO(放热);C+H2O=CO+H2(吸热)。气化炉自热连续运行,制得的煤气由气化炉上部排出,其组成大致为:CO2 26.3%,CO23%,CH47.7%,H240%,N2+Ar2%,煤由炉顶加入,灰渣经炉箅排出,气化压力3.0MPa左右。该法一般用褐煤或部分无烟煤为原料,气化温度900~1000℃,生成气中含有较多的杂质(焦油、轻油、酚、氨、硫化物等),需要处理。由于煤气中CH4含量较高,用作合成氨原料气时,需要在后工序进行处理。该炉型为鲁奇公司开发。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条