1) gas cooled fast reactor
气冷快堆
2) deep burn-up gas-cooled fast reactor
深燃耗气冷快堆
3) wind cooling
气冷
1.
Temperature distribution,deformation and residual stresses of thick plate butt multipass welding were researched through a comparison among normal welding,vibratory welding and welding with wind cooling.
采用振动焊接及气冷的方式与常规焊接对比,研究了埋弧自动焊厚板角接多道焊的温度、变形及残余应力。
4) gas cooling
烟气冷却
5) helium gas cooling
氦气冷却
1.
This article introduced the characteristics of a 10-ton VAR furnace with helium gas cooling and metallurgical quality of GH738 alloy melt with the VAR furnace.
本文介绍宝山钢铁股份有限公司特殊钢分公司最新引进的10吨氦气冷却真空自耗炉主要特点及熔炼GH738合金的冶金质量。
2.
This article introduced the characteristics of a 10-ton VAR furnace with helium gas cooling and metallurgical quality of GH4738 alloy melt with the VAR furnace.
由于采用氦气冷却、瞬时熔速控制和功率因素液滴短路控制弧长等最新技术,显著改善了 GH4738合金的宏观偏析,合金锭各部位的元素分布均匀,H、O、N 含量分别降低至1。
6) air cooling
空气冷却
1.
An analysis of the water cooling, evaporation cooling and air cooling;
水冷却和汽化冷却以及空气冷却探析
2.
The principle and characteristics of KQDL series cupola which supply blast using air cooling,strengthening preheating and single row cyclone were discussed.
论述了“KQDL系列冲天炉”采用空气冷却、强化预热、单排龙卷风供风原理和特点。
3.
Low oxygen pressure cutting by air cooling can reduce the consumed oxygen by 2/3 oxygen compared with traditional ones.
该机采用激光头轴向移动,由电动卡盘带动工件旋转的方法合成切割轨迹,实现了分段式切割,对不同直径的工件无需更换卡块,并采用辅助空气冷却的切割方法实现了低氧压切割,耗氧量比传统设备节省了2/3。
7) Cold Gas Cooling
冷气冷却
1.
Experiment Study of Cold Gas Cooling Based on Green Grinding;
基于绿色磨削的冷气冷却实验研究
8) increasing pressure and gas quenching
加压气冷
9) chlorine gas cooling
氯气冷却
10) cooled crystal with air
气冷晶体
补充资料：改进型气冷堆核电厂
改进型气冷堆核电厂
advanced gas-cooled reactor nuclear power plant
其他部分，气体级冲围板是为了形成再进人气体的流动，同时可防止再进人气体与热气体之间的热交换. 4台燕汽发生器设t在气体级冲围板和压力容器内璧之间的环形空间内。燕汽发生器是一次通过式，以减少压力容器贯穿管的数目。循环风机设t在蒸汽发生器下面。主燕汽发生器下面设有一组排出衰变热用的燕汽发生器，用于反应堆停堆时的冷却。堆总数的3.2%，总功率的2.4%。 结构图中给出了典型的改进型气冷堆的布t情况。堆芯、落汽发生器和循环风机布t在立式圆筒形预一少9011旧x.ng qllengdul hed，OnChong改进型气冷堆核电厂(advaneed gas一eooledreaetor nuelear Power plant)这种改进型气冷堆也采用石且作为怪化剂和结构材料，二氧化铀为核嫩料，但采用不锈钥为嫌料棒的包壳.与镁诺克斯型反应堆(见石!气冷堆核电厂)相比，它的气体冷却剂出口退度提商到670‘C左右，因此燕汽发生器的蒸汽参数较高，可以直接配t标准参数的汽轮机.几个典型的改进型气冷堆的主要参数见表。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条