1) transportation matrix
运输矩阵
2) kinematics output matrix
运动输出矩阵
1.
This paper presents another method based on the screw theory and kinematics output matrix,which can conveniently calculate the degree of freedom of terminal link about serial robot,and meanwhile lay good foundation for researching the parallel robot.
在螺旋理论和运动输出矩阵的基础上,提出了又一种能够便捷地计算串联机器人手臂末杆构件自由度数目的方法,该方法为研究并联机器人打下了良好的基础。
3) transfer matrix
传输矩阵
1.
Analysis on the external cavity laser diode with the theory of ray transfer matrix;
LD外腔结构的传输矩阵理论分析
2.
Research of MEMS-based tunable vertical cavity semiconductor optical amplifiers based on transfer matrix;
传输矩阵法研究MEMS可调谐垂直腔半导体光放大器
3.
Research of gain of vertical cavity semiconductor optical amplifiers based on transfer matrix method;
传输矩阵法研究垂直腔半导体光放大器增益特性
4) transfer matrix method
传输矩阵
1.
The transmission of light wave through one dimensional metallodielectric photonic crystals was simulated by the transfer matrix method.
利用传输矩阵方法 ,从理论上研究了金属插层对由Si SiO2 组成的一维光子晶体中光传输特性的影响 。
2.
Transfer matrix method(TMM) is used to analyed transmission properties of one-dimensional photonic crystal with defect mode,and its situation of properties are study as the change of defect thickness and the number of period.
采用传输矩阵理论,分析了带缺陷的一维光子晶体的传输特性,随缺陷层厚度和周期数变化的情况,并把这种结构应用于微带天线中,通过HFSS软件仿真,结果表明,相比于普通的微带天线,光子晶体天线的谐振频率有所降低,方向性得到了很大的改善。
3.
Secondly, we took TiO_2 and SiO_2 thin films as compositional layers, designed period structures, structures with defect layers as well as their heterostructures, and simulated their PBSs using transfer matrix method (TMM).
利用传输矩阵方法,从理论上研究这些一维光子晶体的带隙特征。
5) Transmission matrix
传输矩阵
1.
In this paper, we carry out the numerical calculating on defect modes of 1D photonic crystal and analyse the defect mode characteristics in detail by the optical transmission matrix method.
本文利用光学传输矩阵理论,对一维光子晶体缺陷层存在和不存在时光子晶体缺陷模进行了研究。
2.
The polarization transmission matrix in electrooptical modulating system is given.
导出电光调制系统偏振传输矩阵 。
3.
By transmission matrix method,the transitivity of the slab can be obtained.
研究了由各向异性左手化材料和右手化材料构成的平板结构,利用传输矩阵方法,确定了平板结构的透射率和反射率。
6) Transfer-matrix
传输矩阵
1.
An introduction is given on the calculation of method of one-dimensional photonic crystals with resonant cavity modes, specially on the method of spectrum and electricity, transfer-matrix method.
介绍了具有共振腔模式的一维光子晶体光谱特性及电场特性计算的传输矩阵方法;基于该结构光学性质如:电场局域态、禁带,综述了其在光学器件中的应用;并提出了需要对该结构进行改进的几个方面。
2.
The optical transmission in an one-dimension Fibonacci supper-lattice composed of right-handed and left-handed materials was investigated by means of the transfer-matrix method.
利用传输矩阵方法研究了光在由正、负折射率介质构成的FC(N)准晶链排列的多层介质膜中传播时的电磁波透射谱性质。
3.
Based on the coupled-mode theory, the transfer-matrix method is used to calculate the transmission spectra ofπphase-shifted long-period fiber gratings(LPPG).
应用耦合模理论和传输矩阵法计算模拟了均匀长周期光纤光栅的透射谱,采用不同的切趾函数对其进行了切趾优化,通过比较得出了最佳的切趾函数。
补充资料：计算机输入/输出控制系统(见计算机输入/输出系统)
计算机输入/输出控制系统(见计算机输入/输出系统)
computer input/output control system
iisuanii shuru/shuehu kongzhi xitong计算机输入/输出控制系统(com-puter inPut/ou中ut eontrol system)见计算机输入/输出系统。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条