1) vacuum relief device
真空泄放设备
2) vacuum relief
真空泄放
1.
This article introduces the general design method of atmospheric vessel's vacuum relief.
介绍了常压容器真空泄放设计的一般方法。
2.
The facilities for overpressure protection and negative pressure protection of LNG storage tank,the parameter setting and the selection considerations,key points of design and installation of pressure and vacuum relief devices are discussed.
介绍了LNG接收站的基本工艺和LNG储罐的基本要求,分析了LNG储罐压力检测内容,论述了LNG储罐超压保护和负压保护的设施、设定参数、压力和真空泄放装置的选择依据与设计安装要点。
3) drainage facilities
放泄设备
4) vacuum relief valve
真空放泄阀
5) drain facilities
放泄设备泄水设备
6) vacuum equipment
真空设备
1.
The service of rubber lining for anticorrosion in production of WPA is introduced, including some key points in design of rubber lining for vacuum equipment, the characteristics of homemade/joint venture/foreign enterprises liner plates and their selection, as well as notices in use.
介绍衬胶防腐在湿法磷酸生产中的应用 ,特别是真空设备设计衬胶防腐的要点以及目前我国湿法磷酸装置中国产 (含合资、独资企业 )胶板的特点和选用、施工中应注意的事项。
2.
The design calculation of the large O ring rubber self energized seal (without bolt and nut )used for the vacuum equipment and its application results are introduced.
介绍真空设备法兰采用大直径Ｏ形环橡胶自紧式密封（不用螺栓和螺母）的设计计算及其应用效果。
3.
This paper introduces application of PP vacuum equipment ,the design and calculation of the vacuum equipment are emphasized .
概述用聚丙烯制作的真空设备的使用情况,着重介绍真空设备的设计与计算,并对不同的计算公式进行了比较,这样便于了解和掌握聚丙烯真空设备的设计和使用。
补充资料：掣掣泄泄
1.随风飘荡貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条