说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 扩孔器与钻头直径之差
1)  shell clearance
扩孔器与钻头直径之差
2)  diameter of ream bit
扩孔钻头直径
3)  near-bit reamer
近钻头扩孔器
4)  Ream bit
扩孔钻头
1.
When wind force cutting pick-up drilling is applyed in coal seam if dedusting equipment is installed in the opening of the bore,it should enlarge drilling bore with ream bit so that dedusting equipment can be installed,and then retreat drilling and replace bit of drill.
在煤层采用风力排渣打钻时,如果在钻孔孔口处安装除尘设备,在打钻前要采用扩孔钻头打一个能够安装除尘器的钻孔,然后退钻更换钻头钻进。
5)  drilling hole diameter
钻孔直径
1.
Through theoretical analysis and experimental data,the effect of matching between piled anchor and drilling hole diameter on anchoring strength was described,and the most reasonable matching parameters of anchor diameter with drilling hole diameter were given.
通过理论分析和实验数据论述了锚杆与钻孔直径匹配对锚固强度的影响,并给出了锚杆直径与钻孔直径最合理的匹配参数。
6)  bit diameter
钻头直径
补充资料:扩孔

holeexpansion:减小空心毛坯壁厚而增加其内、外径的锻造工序称为扩孔。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条