1) shearing deformation
切形变
2) shear deformation
剪切变形
1.
Thixotropic behavior of a semi-solid AlSi6Mg2 aluminum alloy under cyclic shear deformation;
半固态AlSi6Mg2铝合金循环剪切变形下的触变行为
2.
Effect of direction change of shear deformation on rolling textures in high purity Al foils;
剪切变形方向特征对高纯铝箔轧制织构的影响
3.
The effect of shear deformation on the buckling of single-story and single-span frame;
剪切变形对单层单跨框架稳定的影响
3) shear nucleation
切变形核
5) Machining Deflection
切削变形
1.
For calculating machining deflection of the stepped shaft,a universal formula is deduced for variable cross-section cantilever beam bending deflection.
为了计算阶梯轴零件的切削变形,推导出变截面悬臂梁的弯曲变形通用表达式,应用C语言编程计算出控制切削变形误差的工件直径与长度的关系。
6) chip deformation
切屑变形
1.
The investigation on chip deformation and cutting forces of BTA deep hole drilling;
内排屑深孔钻削切屑变形与切削力实验研究
2.
The authors have also accounted for the lowness of actual cutting velocity,discussed various phenomena of the principles for chip deformations in cutting process as well,and analyzed the mechanism of tool wear according to the changes of velocity and radiant condition.
从理论上阐明了滚切刀具切削时名义切削速度、相对切削速度和实际切削速度的定义与作用;推导了它们之间的相互关系式,并证明了实际切削速度较低的原因;论述了切屑变形中各种现象和理论;根据速度变化和散热条件,分析了刀具的磨损机理,得出了滚切刀具切削时以磨料磨损为主的结论。
3.
The analysis of surface roughness and chip deformation provides a foundation to optimize cutting parameters and control surface roughness.
通过分析不同铣削参数下的零件表面粗糙度和切屑变形 ,为高速加工切削参数的选择和表面质量的控制提供依
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条