1) retract line
收缩线
2) linear shrinkage
线收缩率
1.
The effects of pyrolysis temperature and soaking time on ceramic yield,linear shrinkage,mechanical properties and microstucture were investigated.
研究了热懈温度和保温时间对陶瓷产率、线收缩率、力学性能以及微观结构的影响。
2.
The effects are investigated of nano-Al_2O_3powder additive on sintering behaviors of alumina ceramics,such as volume density,water-absorbing rate,porosity,linear shrinkage.
研究了纳米A l2O3粉添加对粗晶氧化铝陶瓷烧结行为,如体积密度、吸水率、气孔率、线收缩率的影响。
3.
The microstructures and properties such as linear shrinkage, ceramic yield and flexural strength of active filler Al_containing polycarbosilane(PCS)_derived ceramics pyrolyzed at different temperatures were investigated.
研究了裂解温度对活性填料Al-聚碳硅烷裂解陶瓷的线收缩率、陶瓷产率、力学性能等的影响 。
3) line contraction percentage
线收缩率
1.
The effects of solidified agent, nanometer silicon dioxide powder and calcium carbonate powder on line contraction percentage of silicon rubber mould were discussed in this paper.
本文主要研究了固化剂、纳米二氧化硅粉和碳酸钙粉等外加剂对硅橡胶模具线收缩率的影响。
2.
The line contraction percentage of the sintered samples were investigated.
通过在原料中添加磷酸盐玻璃粘接剂改善HA生物陶瓷的烧结性能,测定试样的线收缩率,研究了粘接荆对HA植入体烧结的影响。
4) Linear Contraction
线收缩
1.
Development of alloy linear contraction tester with Singlechip Microcomputer;
微机化合金线收缩仪的研制
2.
The effect of rare earth La and Ce on fluidity,free-linear contraction and heat tearing tendency of ZL201 was studied.
研究了稀土La和Ce的加入对ZL201合金流动性、自由线收缩、合金热裂倾向的影响。
3.
Two types of asphalt mixtures with different gradations(AC-13,SMA-13,PA-13) are chosen to study fatigue behavior and linear contraction of asphalt mixture at low temperature in this study.
本文针对高寒地区沥青路面低温开裂现象,选取两种沥青和AC-13、SMA-13、PA-13等三种不同级配混合料进行四点弯曲疲劳、线收缩试验,研究了不同材料及级配对低温下沥青混合料的疲劳性能及收缩性能的影响。
5) shrinkage curve
收缩曲线
1.
The empirical relationship between the matric suction and the void ratio on drying path was established for four types of soils including sand,silt,clay and soft clay by utilizing the shrinkage curves and the soil-water characteristic curves determined through experimental tests.
针对砂土、粉土、黏土和软土4种不同类型土体,结合试样收缩曲线和土水特征曲线分析了土体干燥过程中基质吸力和孔隙比的关系。
2.
The empirical relationship between matric suction and void ratio on drying path for remoulded clay is established by utilizing the shrinkage curves and the soil-water characteristic curves which are determined through experimental tests.
针对非饱和重塑黏土,结合收缩曲线和土水特征曲线探讨试样在干燥收缩过程中基质吸力与孔隙比之间的关系,研究结果表明,当基质吸力增大到某一特定吸力时,基质吸力的增大对试样收缩变形并无显著影响,称此基质吸力为缩限吸力ss。
3.
The results show that the climbing phase of shrinkage curve of fiber after soaking is longer and the turning point is indistinct.
利用热台偏光显微镜,研究了蓝湿革脱铬过程中,皮纤维的热收缩温度、收缩率及其收缩曲线。
补充资料：断面收缩率
分子式：
分子量：
CAS号：
性质：材料的塑料性指标之一。材料受拉力断裂时断面缩小，断面缩小的面积与原面积之比值叫断面收缩率，以ψ表示。单位为%。
分子量：
CAS号：
性质：材料的塑料性指标之一。材料受拉力断裂时断面缩小，断面缩小的面积与原面积之比值叫断面收缩率，以ψ表示。单位为%。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条