说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 吸动位置
1)  pull-up position
吸动位置
2)  operating position
操作位置,工作位置,吸合位置,动作位置
3)  Adsorption site
吸附位置
1.
The role of adsorption sites in the molecular kondo effect;
吸附位置对分子近藤效应的影响
4)  suction slot location
吸气位置
1.
Based on the numerical investigations on the performance of an axial transonic compressor cascade with different suction slot locations and suction mass-flow,it has been shown that for a given inlet Mach number and flow angle,there exist an optimal suction mass-flow corresponding to the suction slot location.
使用MISES程序数值模拟了跨声速吸附式压气机叶栅流场,重点研究了吸气量和吸气位置对跨声速压气机叶栅气动性能的影响。
5)  Position of breathing
呼吸位置
6)  Suction location
吸气位置
1.
The effects of suction locations on the loss are greater as suction flow rate increases.
结果表明,附面层吸除降低了叶栅出口的总损失,并提高了气流的折转能力;吸气位置对损失的影响随吸气量的增大而增大;吸力面采用附面层抽吸对叶展中部区域损失的改善要好于近端壁区。
2.
The influence of the suction location on suction effectiveness is larger than that of the suction air flow rate.
结果表明,附面层吸除可有效改善叶栅气动性能,低能流体被吸除使得吸力面及角区的分离减小,增大了通流能力,叶栅负荷及扩压能力得到提升,且吸气量越大改善越显著,在60%轴向弦长位置吸气效果最佳;吸气位置对吸气效果的影响要大于吸气量,适当增加吸气量可增强吸气效果,最佳吸气位置及吸气量的选定与扩压过程及栅内分离程度相关。
补充资料:特性吸附与半胶束吸附


特性吸附与半胶束吸附
specifical adsorption and hemi-micelle adsorption

texing xifu yu banJ旧oshu xifu特性吸附与半胶束吸附(speeifieal adsorp-tion and hemi一mieelle adsorption)矿物一水界面的吸附的两种形式。特性吸附是因矿物表面与溶液中某种组分(离子或分子)有特殊的亲和力而产生的吸附,也称特殊吸附。特性吸附不仅可以改变电位的数量而且还可以改变电位的符号。例如,刚玉(A12O3)在NaZSO‘或RSO;Na(烷基硫酸钠)溶液中,电动电位随溶液浓度的增大由正值逐渐减小,直至变为负值,说明刚玉对50矛一或RSO不离子有特殊的吸引力。半胶束吸附是水溶液中的表面活性剂在矿物表面产生的吸附,当吸附量达到一定值以后,由于烃基的缔合作用,表面活性剂的离子或分子在矿物表面上形成紧密的吸附层,这类似于溶液中形成的胶束结构,但所形成的“胶束”与溶液中形成的胶束不同,只有二维空间,故称这类吸附为半胶束吸附。矿物表面对胺类捕收剂的吸附,当胺的浓度较大时,常可以产生半胶束吸附。 (龚焕高)
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条