1) observed heat value
观测热值
2) heat value observer
热值观测器
1.
This heat value observer has greater stability robustness and can be integrated into coordinated control system (CCS).
2MPa滑变到12MPa的工况下,取得了将有功功率偏差控制在5MW以内的效果,实践证明该超临界机组在协调控制系统中融入热值观测器有很好的鲁棒性,表明其能够快速响应自动发电控制(automatic generation control,AGC)大幅度变负荷的要求。
3) observed heat value
观测到的热值
4) Observed value
观测值
1.
One kind of observed value error method is suggested,which can branch out the difference in components surface roughness.
在零件表面粗糙度测量和精度评定中,通常的方法是用Rz参数反映零件表面粗糙度,虽然它是个最或然值,但作为精度分析来讲,它不能很充分的反映表面粗糙度的偶然误差特性,为此提出一种以观测值改正数求零件表面粗糙度的观测值中误差方法,它更能明确分出零件表面粗糙度同一系列中的差异。
2.
And it is successful to test and verify this algorithm in the example which observed values were given by Meyer & Roth.
在最小二乘意义下用 Gauss-Newton法拟合三参数双指数曲面z =γ[exp( -αx) +exp( -βy) ]时 ,充分利用观测值 ,应用循环搜索法确定了参数初始值 。
3.
In this paper, an algorithm named the method of cyclic search is suggested to make full use of observed values to determine the initial values of parameters during double exponential curve is fitted in the meaning of least square by means of Gauss Newton method.
提出了在最小二乘意义下用 Gauss-Newton法拟合双指数曲线时 ,充分利用观测值确定参数初始值的一种算法——循环搜索法 。
5) observation value
观测值
1.
The author makes analysis on the negative deviation of evaporation observation value, and puts forward problems that should be given attention to reduce negative values.
对蒸发器观测值出现负值的现象进行了技术上的探讨分析,并提出了减少负值出现的注意点。
2.
Control chart system performs statistic calculation to the data in present spot,and determines statistic value such as mean value of sample observation value or weighted mean value,control chart central line,upper or lower control limit of control .
现场的数据经控制图系统的统计运算 ,确定样本观测值的均值或加权均值、控制图中心线、控制图上下控制界限等统计量 ,并绘制相应的控制图
6) Observation
[英][,ɔbzə'veɪʃn] [美]['ɑbzɚ'veʃən]
观测值
1.
To meet the accuracy requirement of relative positioning,it is necessary to perform the further investigation on the form of CPⅢ(control points Ⅲ) control networks and the precision evaluation of observations from field surveying.
为合理布设CPⅢ网的测量网形,确定CPⅢ网中观测值的必要精度,结合CPⅢ网的标准和改进测量网形,采用边角网间接平差的严密精度估算方法,对CPⅢ网的相对点位精度进行仿真计算,并据此确定了CPⅢ网中观测值的必要测量精度:方向测量精度≤±1,″距离测量精度≤±(1+1×10-6)mm。
补充资料：大坝内部变形观测(见水工建筑物变形观测)
大坝内部变形观测(见水工建筑物变形观测)
daba neibubianxing guanCe大坝内部变形观测见水工建筑物变形观测。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条