说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> K波
1)  K-wave
K波
2)  F K filtering
F-K滤波
1.
With experiment on theoretical and practical data,Linear Radon transform method is much better than F K filtering for linear noise suppression.
介绍了线性 Radon变换方法 ,克服了二维滤波 ( F-K滤波 )由于空间假频现象严重 ,可使信号与噪声有效地分离。
3)  K band
K波段
1.
Two high gain K band MMIC LNAs(low noise amplifiers)on an advanced 0.
25μm PHEMT工艺,给出了两个高增益K波段低噪声放大器。
2.
Major developed countries all regard K band and more upper frequencies applications as primary content of electrical technology.
随着卫星通信的广泛应用,微波频段可供应用的频谱越来越拥挤,世界各主要发达国家都把K波段以及K以上波段的开辟作为其电子技术发展的主要内容之一。
3.
A new kind compact size k band bandpass filter with a transmission zero in the upper band is proposed in this paper.
本文介绍了一种新型的小型化k波段带通滤波器,基于多路径传输原理,此滤波器在频率的高端产生了一个传输零点,因而有很好的阻带抑制特性和矩形度。
4)  K-band
K波段
1.
Design of on Ultra-low Noise K-band Amplifier;
超低噪声K波段放大器仿真设计
2.
Design of a Miniaturized K-band Down-converter Module;
小型化K波段下变频组件的设计
5)  F-K filter
F-K滤波
1.
The ability of f-k filter to suppress ground roll is enhanced by adjusting energy and moveout between tr.
通过对面波能量和道间时差调整,使面波干扰更接近真正意义上的线性同相轴,可以增强利用f-k滤波压制面波的能力,在一定程度上消除面波干扰对转换波处理的影响。
6)  F-K filtration
F-K滤波
1.
In consideration of the phenomena of coherent interference of strong surface waves and strong linear interference existed in the pre-stack process of seismic exploitation in west China,starting from compressing the integrated strong coherent interference with conventional F-K filtration method,the shortcomings of the method are analyzed.
针对我国西部地区地震勘探叠前记录中同时存在强面波和强线性干扰等相干干扰的现象,从利用常规处理的F-K滤波方法压制这种综合强相干干扰出发,分析了该方法的不足,并提出了利用离散二维小波变换同时压制强面波和强线性干扰共存的强相干干扰的方法,同时提出了改进措施。
2.
F-K filtration is a good method for pre-stack noise removing, but if it is not used properly, and the ideal conditions of the F-K filter are not sufficed, the result of filtration will deviate consi.
F-K滤波是一种很好的迭前去噪手段,通过分析研究,总结了一套F-K滤波的处理流程,并取得了很好的效果。
补充资料:波数字滤波器
      由两端终接电阻负载的无源LC梯形滤波器导出的一种数字滤波器结构。应用双线性变换S=k(1-Z-1)/(1+Z-1)可将用波参数描述的无源元件,实现为数字元件。表1列出了无源元件R、C、L及其对应的由延时单元、乘法器和加法器构成的数字元件。
  
  
  通常高阶递归型数字滤波器的级联型或并联型有产生极限环振荡的危险。此外,在输入信号非常小时,由于舍入误差的高度相关,也可能导致数字滤波器的不稳定而产生固定振荡。1971年,提出波数字滤波器的伪无源性概念,并论证了这种数字滤波器的低灵敏度特性。波数字滤波器具有良好的稳定性,可以用较短的系数字长实现,有良好的动态范围,不会出现极限环振荡(即在环路情况下应用也不会出现任何杂散振荡)。这种数字滤波器特别适用于通信系统。
  
  在波数字滤波器结构中,用波参数描述的元件,在联接时必须遵从端口间阻抗匹配的原则。相应地,数字元件之间的联接按其为串联或并联分别采用由乘法器和加法器构成的串联适配器或并联适配器匹配联接。适配器符号及其对应的联接关系见表2。图为三阶椭圆型低通LC 梯形滤波器及其等效的波数字滤波器。  波数字滤波器的另一种结构称为波格型数字滤波器,是由对称型或格型无源LC 滤波器导出的。
  
  

参考书目
   A. Antonious, Digital Filter : Analysis and Design,McGraw-Hill Co.,New York,1979.
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条