1) habit
[英]['hæbɪt] [美]['hæbɪt]
矿物结晶形态;习惯
2) crystallization phase
结晶矿物
1.
The effect of Li_2O and B_2O_3 doping on the crystallization phase composition of mold fluxes bearing rare earth oxide was investigated by lithofacies and energy chart analysis in scanning electron microscopy.
通过在结晶器保护渣中添加Li2O和B2O3作助熔剂,在实验室内模拟渣膜的形成条件,结合岩相和扫描电镜能谱分析,研究了Li2O3和B2O3对含稀土氧化物保护渣结晶矿物组成的影响。
2.
Influence of little Li_2O and B_2O_3 on the crystallization phases of mold fluxes containing rare earth oxide was investigated by the methods of lithofacies and SEM enrage chart analysis in this paper.
本文通过在保护渣中添加少量Li_2O和B_2O_3,结合岩相和扫描电镜能谱分析,研究了其对含稀土氧化物保护渣结晶矿物组成的影响,得到如下结论:(1)稀土氧化物可以促进保护渣中枪晶石析出,抑制玻璃相形成,增大保护渣析晶率;(2)当稀土氧化物含量达到一定数值,在保护渣结晶矿物中可以形成稀土硅酸钙相,稀土氧化物继续增加,会有未溶稀土氧化物固态质点出现;(3)保护渣中加入少量B_2O_3和Li_2O,可以促进硅灰石析出并抑制枪晶石形成,也可以有效抑制高熔点稀土硅酸钙形成,防止渣膜形成过程中过早析出高熔点物相。
4) crystalline morphology
结晶形态
1.
Effects of Nucleator on Crystalline Morphology and Mechanical Properties of Polypropylene;
成核剂对聚丙烯结晶形态和力学性能的影响
2.
Isothermal crystalline morphology of isotactic polypropylene (iPP) with clarifying nucleator - TM-3 was observed by polarized light microscope.
利用偏光显微镜观察了等规聚丙烯(iPP)在透明成核剂TM-3作用下的等温结晶形态,并与普通成核剂苯甲酸钠的影响作了对比。
3.
Their crystalline morphology was characterized by using polarizing light microscopy,which were contrast to HDPE/elastomer blends.
通过DSC分析仪和偏光显微镜研究了共混物的熔融、结晶行为和结晶形态,并将其结晶形态与简单共混对照样加以对比研究。
5) morphology
[英][mɔ:'fɔlədʒi] [美][mɔr'fɑlədʒɪ]
结晶形态
1.
in order to understand the toughness mechanism of HDPE/HAP composite prepared by in situ biomineralization,the crystallization kinetics and morphology of HDPE/HAP composite were investigated.
研究了原位矿化复合方法对HDPE/HAP复合材料中HDPE的结晶形态及结晶动力学的影响,结果表明,原位矿化复合方法制备的复合材料中HDPE主要以放射状伸直晶形式存在,HDPE晶粒细小,结晶度高,且HAP与HDPE界面结合紧密。
2.
The morphology of the.
用示差扫描量热法(DSC)研究了蒙脱土对聚丙烯及马来酸酐接枝聚丙烯的非等温结晶行为的影响;用偏光显微镜(POM)观察了聚丙烯及共混体系的结晶形态,估算了径向生长速率。
3.
Research on Self-nucleation of Copolymer Polypropylene and the Crystallization Kinetics and Morphology of High Impact Polypropylene Copolymer;
高抗冲聚丙烯(HIPP)与等规聚丙烯(iPP)结晶动力学、结晶形态进行研究发现,HIPP的结晶温度和熔融温度均低于iPP,等温结晶动力学表明,HIPP与iPP相比较,半结晶时间要长,结晶活化能和端表面自由能也要高。
6) Crystallization morphology
结晶形态
1.
The crystallization morphology of PCL in the blends can be changed with the crystallization temperature and the NC content obviously.
聚己内酯结晶形态随结晶温度和共混物组成的变化表明 ,在共混体系中聚己内酯结晶速率与非晶第二组分的扩散速率存在一定的匹配关系 ,是影响环带球晶形成的重要因
2.
The crystallization morphology and isothermal crystallization process were studied by means of polarized microscope and DLI(Depolarized Light Intensity) for poly(ether ester) block copolymers.
采用偏光显微镜和光学解偏结晶速率仪研究了嵌段聚醚酯共聚物的结晶形态和等温结晶过程。
补充资料：二次再结晶(见再结晶晶粒长大)
二次再结晶(见再结晶晶粒长大)
secondary recrystallization
erCI 201」le」Ing二次再结晶(seeondary reerystallization) 见再结晶晶杠长大。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条