1) closed annular outcrop
封闭环形露头
2) asphalt seal
沥青封闭层;沥青露头
3) closed-toe
封闭袜头
4) toe dosing;toe dosuse
袜头封闭
5) closed joint
封闭接头
6) closed loop
封闭环
1.
The closed loop dimension and tolerance is calculated in order to calculate and check allowance and allowance tolerance.
通过封闭环尺寸及公差计算,计算并校核余量及余量公差。
2.
It must start from the confirmation of closed loop and retrieval of component loop, draw the line graph of dimension chain correctly and work out relevant procedure dimension and tolerance by using basic formula of dimension chain according to the types of dimension chain of craftwork.
解算尺寸链应从封闭环的确定、组成环的查找入手,准确画出尺寸链线图,根据工艺尺寸链的类型,利用尺寸链的基本计算公式计算出有关工序尺寸及公差。
3.
Based on the principal regulation of that dimension obtained indirectly must have accumulated errors, this paper, by means of accumulated errors and generality, mainly discusses the essentiality of dimension chain and analyzes the establishment of closed loop that can embody accumulated errors in technological dimension chain.
以"间接获得尺寸必然会有加工误差的累积"这一基本规律作为分析问题的基础,着重以误差累积与综合说明尺寸链关系的实质,侧重分析"体现误差累积的封闭环的确定,运用于工艺尺寸链中"。
补充资料：袜头褲
1.即膝裤。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条