1) surface exclusion
表面排阻
2) Surface Resistance
表面电阻
1.
Strain effect on microwave surface resistance of YBa_2Cu_3O_(7-δ)/LaAlO_3 and Tl_2Ba_2CaCu_2O_8/LaAlO_3 high temperature superconducting thin films;
YBa_2Cu_3O_(7-δ)/LaAlO_3和Tl_2Ba_2CaCu_2O_8/LaAlO_3高温超导薄膜内的应变对其微波表面电阻影响的研究
2.
The surface resistance Rs was measured by the four-probe method described in ASTM F 390.
分别用四探针法(ASTM F390)和双轴传输线法(ASTM D 4935-99)测量导电涤纶织物的表面电阻和电磁屏蔽效能。
3.
The results showed that the material with 5% content of carbon black could meet the requirement of the performance of motor blower fan material as the surface resistance reaching 1×108Ω.
结果表明,炭黑的质量分数为5%时,材料表面电阻率为108Ω数量级,力学性能优良,达到电机用塑料风叶材料的指标要求,并可应用于其它对抗静电性能要求较高的场合,用于制造某些结构件。
3) Surface resistivity
表面电阻
1.
Antistatic properties of carbon black (CB) filled plasticized poly(vinyl chloride) (PVC) were studied using surface resistivity tester and SEM.
采用表面电阻测试和扫描电镜 ,分析研究了软质聚氯乙烯 (PVC)树脂与炭黑 (CB)复合体系的抗静电性与炭黑含量、分布形态、PVC树脂型号及混炼塑化工艺之间的关系。
2.
When nonionic electrostatic resistant is mixed with assistant electrostatic resistant,the composite's surface resistivity will be reduced to 3×10 8Ω or below.
实验结果表明 ,八溴联苯醚与 Sb2 O3 互配体系的氧指数可达 2 7以上 ;非离子型抗静电剂配以辅助抗静电剂 ,可使材料的表面电阻降至 3× 1 0 8Ω 以
3.
In fact,the surface resistivity of these composites is analyzed.
研究复合材料的热性能、微观结构、表面电阻和结晶行为,结果都表明OMMT对PA66有明显的影响。
4) high impedance ground plane
高阻表面
1.
Impact of a cover layer to high impedance ground plane band-gap;
介质覆盖对高阻表面带隙的影响
2.
Conformal mapping-based method and partial capacitance method are given to accurately calculate inter-digital capacitance and the inter-digital high impedance ground plane(HIGP) design formulas are revised.
本文采用保角变换法和电容拼接技术对交指形电容进行精确的计算,对交指形高阻表面光子晶体设计公式进行了改进。
5) drag-reduction surface
减阻表面
6) High impedance surface
高阻表面
1.
High impedance surface(HIS) is a kind of local resonance microwave photonic crystals,and its reflection phase is the phase difference between the backward and forward travelling waves at the interface when a plane wave incident the surface vertically.
高阻表面是一种局域谐振型的微波光子晶体,它的反射相位是指平面波垂直照射时,界面处后向行波与前向行波的相位差。
补充资料：表面电阻
分子式：
CAS号：
性质：在试样同一表面上，两平行刀状电极间的表面电阻是加到两电极间的直流电压除以流经两电极间试样表面的电流所得到的商，单位为Ω。是表征材料表面抵抗电压的一种量度。
CAS号：
性质：在试样同一表面上，两平行刀状电极间的表面电阻是加到两电极间的直流电压除以流经两电极间试样表面的电流所得到的商，单位为Ω。是表征材料表面抵抗电压的一种量度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条