1) rod boring machine
杆式镗床
2) tool bar of boring machine
镗床刀杆
1.
The improvement on tool bar of boring machine is introduced,and the design of position die for drilling hole of guiding-rod and the design of location clamping tool for drilling hole on common lathe are also elaborated.
主要介绍了镗床刀杆改进、设计导杆孔胎以及设计车床用钻孔卡具的方法,解决了ZY3600/9。
3) boring machine for cutting connecting rod
连杆镗床
4) horizontal boring machine
卧式镗床
1.
Noise in the headstock box of horizontal boring machine was found mainly from this impact.
从理论上分析了齿轮基节误差、齿形误差和公法线长度对齿轮啮合冲击的影响,说明齿轮啮合冲击是卧式镗床主轴箱的重要噪声源,根据卧式镗床TX6113A/1主轴箱的齿轮传动结构特点,利用频谱分析技术,找出噪声源,对齿轮进行修整,将噪声从85。
2.
This paper shortly introduces a living example that transforms electric control circuit of horizontal boring machine using programmable logic controller (PLC),increasing the reliability of system from hardware and software.
简要介绍了利用 PL C改造卧式镗床电气控制线路的应用实例 ,从硬件和软件两方面提高了系统的可靠
5) duplex boring machine
复式镗床
6) vertical boring machine
立式镗床
补充资料：卧式镗床（镗杆直径≥160mm）
| ||||||
（一）几何精度 | ||||||
坐标定位精度（mm） | ＜0.02 | 0.03~0.05 | 0.06~0.10 | ＞0.10 | ||
（二）加工精度 | ||||||
1、圆度允差（mm） | ＜0.01 | 0.01~0.015 | 0.015~0.025 | ＞0.025 | ||
2、表面粗糙度Ra值（μm） | ＜0.8 | 1.6 | 1.6 | ＞1.6 | ||
（三）控制系统 | ||||||
具备数控数显装置 | 有 | 部分有 | 无 | 无 | ||
（四）噪声dB（A） | ＜82 | 83 | 84~85 | ＞85 | ||
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条