1) lamination theory
叠层理论
2) thermal laminated theory
热叠层理论
3) superposition theory
叠加理论
1.
Results show calculation results of AIJ based upon superposition theory are in good agreement with experimental results.
在总结国内外钢管混凝土短柱计算公式的基础上,结合试验中的矩形钢管混凝土短柱,应用相关规范进行计算,并与试验结果进行对比,指出采用叠加理论的AIJ计算结果与试验结果吻合较好。
2.
Study on calculation method and mechanical property of crisscross section column composed of concrete-filled square steel tubes is done by three methods:superposition theory,finite element analysis and axial compression experiment.
在钢筋混凝土异形柱和异形钢管混凝土柱的基础上,提出了一种异形柱形式———十字形截面方钢管混凝土组合异形柱,通过理论计算和有限元分析得到了异形柱的破坏形态及极限承载力,并采用叠加理论推导了其换算长细比计算公式。
3.
Based on characteristics of L-shaped short composite column of concrete-filled square steel tubes(LCSC),research on calculation method and ultimate load-carrying capacity under axial compression for the special-shaped column is done by three methods: superposition theory,finite element analysis and axial compression test.
按照单肢高宽比等于4的原则,设计制作了L形组合短柱试件,计算采用叠加理论公式,得到试件的轴压极限承载力为3 720 kN;有限元分析采用壳单元、实体单元和接触单元,得到试件的轴压极限承载力为3 518 kN;轴压试验得到试件极限承载力为3 975 kN。
4) theory of superposition
重叠理论
5) Overlapping principle
叠层原理
6) Angular Overlap Model
角重叠理论
1.
The d orbital energy levels in triprismatic and octahedral coordinate structures and the intermediate states between triprismatic and octahedral coordinate structures have been calculated by using Angular Overlap Model (AOM).
采用角重叠理论的方法,计算了三棱柱和八面体以及介于两者之间配体场的d轨道分裂后的能级,由此解释了造成JahnTeller效应的原因是键角的变化,而非键长的变
补充资料：层岩叠壑图
中国画。清代髡残作。纸本立轴。浅设色。画面景物繁复。上方左角大江浩淼，帆影依稀；右角山峰高峻，瀑流奔壑，山径左曲，至中幅复右折。近景绿树掩映，茅屋临溪。笔法苍秀醇厚，有雄奇磊落之致。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条