1) measurement deviation
测定偏差
2) declination determination
偏差测定
3) tracking error
偏航测定误差
4) basis weight difference
定量偏差
1.
The properties of the sheet formed on this vat was determined,the results showed that this vat had better stock distributing and sheet forming properties and the sheet had less basis weight difference incross direction,the paper strength in MD was similar to that in CD.
介绍了孔板布浆导流短孤形板网槽的结构，并对其成形纸页性能进行测定，结果表明，这种网槽有较好的布浆成形性能，纸页横幅定量偏差较小，纵横向强度比较接近。
5) prescribed skew
给定偏差
1.
This paper proposes a new algorithm for prescribed skew clock routing.
提出一种时钟树布线算法,在给定偏差约束下,采用新的匹配策略考虑偏差约束进行局部拓扑优化,优先匹配延迟目标大的结点,将其置于时钟树拓扑结构底层;结合缓冲器的插入,抑制了蛇行线的产生。
6) location deviation
定位偏差
1.
The linear measurement principle of flattened diameter of the ocular cornea and the location deviation of the cone prism which is used in the applanation tonometer are introduced.
介绍了用于压平眼压计的圆台压平棱镜进行角膜压平直径线性测量原理及定位偏差分析;着重讨论了光通量补偿及角膜压平面积线性测量原理;也介绍了利用计算机图形学设计和制作通量补偿片的方法。
2.
In view of large location deviation of the feature point images in vision-based pose measurement of parallel mechanism,a compensation method is proposed on the basis of approximation solution of parallel mechanism pose.
针对并联机构位姿视觉测量中特征点像点定位偏差大的问题,提出了基于并联机构位姿近似求解的补偿方法。
补充资料：逼近函数的偏差
逼近函数的偏差
deviation of an approxmating function
通近函数的偏差【山血位扣of ana即.油加tiI犯如‘丘.;yoo.e。。e np:6二:狱a沁川e‘中y。二明。。1 逼近函数g〔K和一个给定函数f任叨之间的距离p匆，f).在同一个类叨内可以考虑用不同度量p，譬如一致度量 p(g，f)一碧笃}g(x)一f(x)I，以及积分度量 /(。，，)一(i一(·)一，(·):“·)’‘’，p一和别的度量.至于逼近函数的类K则可以用代数多项式、三角多项式，还有f关于某个正交系的正交展开的部分和，这些部分和的线性平均，以及一些别的集之、
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条