1) taper pressure ring
斜接压力环
2) plain pressure ring
平接压力环
3) oblique contact
斜压接触
1.
The finite element model for contact analysis between roller and tyre under oblique contact status was established,the 3D contact finite element modeling program between roller and tyre under mixed coordinate was developed.
建立了能精确反映托轮滚圈斜压接触的有限元模型,开发了一套完整的建立在混合标架下的托轮滚圈的三维接触有限元建模程序。
2.
The character of the oblique contact model between kiln roller and tyre was studied,the build-up procedure of oblique contact model between kiln roller and tyre was developed,which is apt to the finite element analysis of roller and tyre under the condition of any load,load rate,oblique angle.
研究了斜压状态下托轮滚圈多体接触模型的特点,开发了斜压接触下托轮滚圈有限元建模程序,该程序适用于任何载荷、载荷比、偏斜角下托轮滚圈的接触有限元分析。
4) baroclinic circulation
斜压环流
1.
In the context of the 1958~1997 NCEP/NCAR reanalyses,the south Asian high (SAH) is vertically divided into two components,barotropic and baroclinic circulations,whereupon the conversion features are addressed of the SAH during its seasonal variation.
利用1958~1997 年的 N C E P/ N C A R 再分析资料,采用将大气环流在垂直方向分解为正压和斜压环流两个分量的方法,讨论了南亚高压季节演变中的正斜压环流的转换特征。
5) baroclinic solenoid
斜压力管
6) barodine force
斜张压力
补充资料:固定斜管微压计
分子式:
分子量:
CAS号:
性质:一种简单的微压计。主要由容器和固定斜管构成。当测量正压力时,需要测量压力的空间与容器接通,而当测量负压力时,则与斜管接通。当测量压力差时,将较高的压力与容器接通,而将较低的压力与斜管接通。所求的微压或压力差可由斜管的倾斜角度α、管内液面升高度h1和容器内液面下降度h2等算出,一般将h2忽略,由h1直接读出。如斜管倾斜角度可以改变,则称可动斜管微压计(movable-inclined-tube micromanometer)。
分子量:
CAS号:
性质:一种简单的微压计。主要由容器和固定斜管构成。当测量正压力时,需要测量压力的空间与容器接通,而当测量负压力时,则与斜管接通。当测量压力差时,将较高的压力与容器接通,而将较低的压力与斜管接通。所求的微压或压力差可由斜管的倾斜角度α、管内液面升高度h1和容器内液面下降度h2等算出,一般将h2忽略,由h1直接读出。如斜管倾斜角度可以改变,则称可动斜管微压计(movable-inclined-tube micromanometer)。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条