3) re-heater
再热器管
1.
Tubing leakage occurred of a re-heater at Fushun power plant,the relevant case analysis results showed that the leakage was induced by corrosion of the solved oxygen in the water under scale on the tube surface,which then resulted in thinning of the tubing wall and finally in perforation of the tubes.
采用化学分析、金相分析,扫描电子显微镜等手段对抚顺发电有限责任公司2号炉低温再热器管泄漏原因进行了分析。
4) hot reheat steam pipe
热再热管道
1.
Surface defects have observed on outside surface of four hot reheat steam pipe bends,on the basis of the performed inspections and analysis,conclusion have been made as follows :the defects observed on outside surface of the four pipe bends are laps which can be attributed to improper heating the ingots and improper rolling parameters.
某300 MW热电机组热再热管道4支钢管在中频弯制中出现横向开裂,通过对成分、组织性能和在现场进行宏观检验,基本判定开裂原因是由于热轧参数不正确或坯料加热不良等原因在热轧中产生折叠,而所产生折叠在后续的外表机加工工序中未被充分去除所致。
5) Preheating coil pipe
预热盘管
6) heating coil
加热盘管
1.
The analysis and test of the corrosion characteristics, corrosion product, pipe corrosion forms, surface composition and impurities, media and environment impact of the coils concludes that the corrosion of the heating coils of the 3 - phase separator is mainly the external wall corrosion by carbon dioxide and oxygen in the waster water.
通过对盘管腐蚀外貌特征、腐蚀产物、管材腐蚀形貌、表面成分及夹杂物、介质及环境影响等方面的分析、试验,指出宝浪油田三相分离器加热盘管的腐蚀主要为污水中的二氧化碳和氧对盘管外壁的腐蚀,其腐蚀速率随环境温度升高而增加。
2.
This method,utilizing the difference of oil and water in physical property,is used to examine the leakage of return water and the oil floating on the water surface though transparent glass tube and separating concave slot installed in original heating coil return water pipe system.
介绍了一种储油罐加热盘管泄漏锅炉回水检测技术,给出了其在实际应用中的特定工艺规程。
3.
The heat-transfer between the wall of the heating coil and the crude oil is the bottleneck which restricts the heat-transfer efficiency of the heating coil.
加热盘管内壁与原油的换热,是制约盘管换热性能的重要瓶颈,加热盘管的传热规律目前缺乏系统研究,迄今为止还没有为大家所公认的、经得起实践考验且精确度较高的计算方法。
补充资料:4063m~(3)高炉热风炉分离式热管换热器
4063m~(3)高炉热风炉分离式热管换热器
1270
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条