1) positive voltage
正电压
2) voltage correction
电压校正
1.
At first, to enable cutset vulnerable index to reflect the trajectory of fault, voltage correction is used, thus the vulnerable cutset can be chosen more accurately; the.
首先引入电压校正方法,使割集脆弱性指标能够反映故障轨迹,从而更为准确地筛选脆弱割集,然后根据基于割集的灵敏度分析方法选择紧急切机和切负荷的地点。
3) forward voltage
正向电压
1.
Temperature characteristics of the forward voltage of GaN based blue light emitting diodes
GaN基蓝光发光二极管正向电压温度特性研究
2.
In the Voltage-Method,we show that the forward voltage depends on the junction temperature linearly with uniform current.
用正向电压法、管脚法和蓝白比法等三种方法测量GaN基白光LED的结温,获得了较为准确的结温,误差可以控制在4℃以内。
3.
In order to obtain an excellent ceramic coating,it is important to investigate effects of forward voltage and oxidation time on characteristics of micro-oxidation film of ZAlSi12.
因此,研究正向电压、氧化时间对 ZAlSi12微弧氧化陶瓷层特性的影响规律,对于获得良好的陶瓷表面层有着重要的意义。
4) Fuel compensation
电压修正
5) positive sequence voltage
正序电压
1.
To address the problem of zero sequence direction relay’s non-operating under the zero sequence voltage’s threshold, a new method of phase comparison is presented by using positive sequence voltage instead of zero sequence voltage.
针对上述问题,文中系统阐述了各种不对称接地故障下,系统各点故障前后正序电压的相位偏差、过渡电阻对各序分量相位的影响、正序与零序电压间最大相位偏差、送端与受端功角对该相位差的影响等,并据此提出了零压不够时采用正序电压代替零序电压进行比相的补充方案。
6) normal-voltage
正常电压
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条