1) parliament heel
轻微倾侧
3) camber
[英]['kæmbə(r)] [美]['kæmbɚ]
侧倾
1.
FEA of belt deformation of radial tire on camber rolling state;
侧倾滚动轮胎带束层受力状态有限元分析
2.
FEM analysis of contact characteristics of rolling radial tire on camber and corner;
滚动轮胎侧倾侧偏接地性能有限元分析
3.
Review of Tire Brush ModelsⅢ.Non-steady State Cornering and Turn slip as well as Steady State Camber Brush Models;
轮胎刷子模型分析Ⅲ.非稳态侧偏、转偏及稳态侧倾刷子模型
4) rolling
[英]['rəʊlɪŋ] [美]['rolɪŋ]
侧倾
1.
Study on Effect of Rear Axle Parameters on Spiral Spring Dependent Suspensi on Rolling Angular Stiffness;
后桥参数对螺旋弹簧非独立悬架侧倾刚度影响研究
5) tripping
[英]['tripiŋ] [美]['trɪpɪŋ]
侧倾
1.
According to different calculation methods for comparative analysis and discussion to the results of buckling stress of tripping for stiffeners,the paper gets a practical alternative formula based on the formula of Bleich.
根据不同计算方法对骨材侧倾的屈曲应力计算结果的比较分析与讨论,基于Bleich公式,得出实际可行的计算公式。
2.
The paper based on the energy method derives a method for solving the dynamic tripping buckling problem of thin walled stiffeners in stiffened plate under periodic dynamic loading.
基于能量法推导出了加筋板中薄壁骨材承受轴向周期载荷时的侧倾动力不稳定区的求解方法 。
3.
In predicting tripping stress of stiffeners in stiffened panels it is necessary to calculate the local buckling strength of plate.
本文研究分析船体骨材的侧倾屈曲问题,分析中考虑了板屈曲对骨材侧倾的影响。
6) roll
[英][rəʊl] [美][rol]
侧倾
1.
Dynamic simulation of the roll on articulated off-road vehicles;
铰接式非公路车辆侧倾过程动态仿真
2.
Simulation and Study of Vehicle Roll Active Control System;
汽车侧倾稳定主动控制系统的仿真研究
3.
The Application of ADAMS in Research of Automotive Roll Movement;
基于ADAMS的车辆侧倾运动研究
补充资料：轻微
1.细小，细微。 2.菲薄，微薄。 3.卑微，微贱。 4.程度浅。 5.不重要。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条