1) injection advance angle
喷射提前角
2) injection advance
喷射提前
3) advanced injection angle
喷油提前角
1.
By using 3-D CFD method,the spray and combustion of a model 490 turbocharged DI diesel engine with different advanced injection angle were simulated.
在考虑进气涡流比的情况下,对某490增压直喷柴油机不同喷油提前角下的缸内喷雾及燃烧过程进行了三维CFD模拟,给出了4种不同喷油提前角时的缸内火焰、NOx和Soot的时空分布。
2.
CFD method was applied to simulate one high-speed turbo-charged DI diesel engine s combustion process,and the mixed gas,the temperature and the soot distribution in-cylinder in different advanced injection angles were obtained.
应用计算流体动力学对某小型高速增压直喷式柴油机缸内燃烧过程进行了数值计算,得出了不同喷油提前角下增压直喷式柴油机缸内混合气、温度和碳烟的分布情况,分析了不同喷油提前角下,上止点前后的喷油量的比例对碳烟排放的影响,并通过实际工况下的碳烟排放试验进行了验证。
4) hydrogen injection advanced angle
喷氢提前角
5) injection timing
喷油提前角
1.
The Influence of Fuel Injection Timing on Exhaust Emission From a Diesel Engine;
喷油提前角对柴油机排放影响的研究
2.
Injection pressures, drive torque for EUP and low pressure of fuel were collected and filtered, and the peak injection pressure, injection timing, peak torque value and their differences among 6 cylinders were calculated and achieved for the analysis of an EUP assembly.
介绍了基于研华PCI-1712高速数据采集卡设计的电控单体泵采集分析系统,分别采集了喷油压力、单 体泵驱动扭矩和燃油低压信号,并对信号进行滤波和计算,获得了单体泵的最大喷油压力及散差、喷油提前角及散 差、峰值扭矩及散差等参数,用于电控单体泵的分析。
3.
The influence of injection parameters including the nozzle diameter and injection timing on the spray and combustion process of dimethyl ether(DME)was investigated.
对发动机喷油系统参数对二甲醚(DME)喷雾燃烧过程的影响进行了实验研究,包括喷孔直径和喷油提前角对喷雾燃烧过程的影响。
6) advance angle of fuel
提前喷油角
补充资料："抢跑/提前行动"
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条