1) angle pitch
角节
3) facet-joint angle
小关节角
1.
Methods A series of new effective computer aided design(CAD) methods such as modified "no-seed region segmentation" and non-parallel "best cross-section planes" were used to accurately establish finite element(FE) models of the lumbar L4～L5 segment,representing the variation of disc height,facet-joint angle and lordosis angle of .
方法:采用改良的“非种子区域分割方法”及非平行“最佳切割平面”等一系列新型计算机辅助设计(CAD)方法精确建立包括椎间盘高度、腰椎小关节角、椎间盘前凸角改变的L4~L5活动节段有限元模型;在2700N轴向压缩载荷条件下,分别对各有限元模型的峡部、小关节应力、小关节接触力以及椎间盘负载进行测试。
4) pitch point angle
节点角
1.
In this paper, a new formula is presented to solve for the pitch point angle σ_p.
出了求解锥蜗杆传动节点角的新公式,并以节点角最佳取值范围图作为设计的依据。
5) the panel zone
转角节点
1.
This paper mainly investigates the load capacity of the side panel zone in steel gabled frames by static test of four connections by comparing the panel zone with and without the inclined stiffener.
当工程中门式刚架转角节点处,梁、柱处于正弯矩作用即转角节点域外翼缘受压时,建议架设斜加劲肋以防止结构失稳。
6) pitch cone angle
节锥角
1.
The relative speed of the conjugated contact points,the pitch cone angle of the conjugated pitch cone and the meshing equation of the bevel gear pair were established orderly based on both the space coordinate transformation and the meshing theory.
在对数螺旋线齿锥齿轮齿面形成及齿面方程分析的基础上,建立了该齿轮啮合分析研究的数学模型,利用空间坐标变换及经典空间啮合理论的方法,确定了啮合齿面共轭接触点的相对速度,并通过对相互啮合两齿轮共轭节锥的节锥角间的关系分析,从而建立了齿轮副的啮合方程。
补充资料：角节
1.犀角制的符节。周代都鄙大夫遣使所用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条