1) mean down time
平均停歇时间
2) cease time
停歇时间
1.
Through testing the relation between impulse width, cease time, discharge voltage, discharge time and pasteurization effect has been explored.
本文考察放电因素即:脉冲宽度、停歇时间、放电时间、放电电压对杀菌效果的影响,得到了脉冲放电杀菌的最佳参数组合;放电时间与液体的残菌浓度对数值之间的关系。
3) average residence time
平均停留时间
1.
It is found that this device can efficiently reduce the maximum average residence time difference of individual flows in the model from 546 s to 50 s and the dead regi.
该装置在模型中能有效地将各流之间的最大平均停留时间差从546 s降到50 s,死区从26。
2.
The relation between catalyst efficiency and average residence time of reaction mass in a continuous operation reactor was developed based on the kinetics principle of coordinative polymerization.
以配位聚合动力学为基础 ,推导出了连续聚合反应器中催化剂活性与物料平均停留时间的关系 ,从而找出了气相流化床反应器在冷凝态操作时对催化剂动力学常数的要求 ,并得到了由动力学常数和平均停留时间计算催化剂效率发挥程度的方法。
3.
“Stimulate-Response”technology is applied in the organic glass model with the ratio of 1:3 to analyse the average residence time (ART) and the fluid flow pictures, also to research on the critical height.
本研究在1:3缩小比例的有机玻璃模型中,采用“刺激——响应”的实验技术,对8种方案条件下流体在中间包内的平均停留时间及染色体流场照片进行了分析,对旋涡卷渣的临界高度和夹杂物的去除进行了理论与实验研究。
4) mean residence time
平均停留时间
1.
The circulation flow rate,mixing time,mean residence time,volumetric mass transfer coefficient of the RH refining process were determined by water modeling.
通过物理模拟测定了RH精炼过程的循环流量、钢包的均混时间、真空室内物料的平均停留时间及容量传质系数,重点分析了RH上升管内的提升气体用喷嘴个数及其布置对上述4个方面特性的影响。
2.
With the hydraulic model experiment on the tundish of single strand slab continuous caster,the slag involved in the mould and the RTD curve as well as the mean residence time of molten steel in the tundish under different conditions are measured.
对我国某钢厂单流板坯连铸机中间包进行了水模型实验研究,测定了不同条件下中间包的下渣量和中间包钢液的RTD曲线及平均停留时间,用NOSA统计软件对测试结果进行了数据处理。
3.
Measurements of mean residence time and penetration of submicrometer aerosols in flows in tubes were made within the range of Reynolds numbers from 0.
实验发现 :气溶胶粒子在毛细管扩散池组中的平均停留时间滞后于流体平均停留时间 ;气溶胶粒子在毛细管扩散池组中的穿透率随流体运动速度和气溶胶粒子粒径的减小而显著减小 。
5) average stopping time
平均停靠时间
6) expected downtime
平均停机时间
1.
Research of the expected downtime for repairable system with single repairman vacation;
修理工单重休假可修系统平均停机时间研究
2.
By theories of renewal process and geometric process,the optimal policies N* and T* are decided so that the long-run expected downtime per unit time on each replacement policy is minimal.
研究了由一个修理工、两同型部件组成的冷贮备可修系统,在故障部件不能"修复如新"的条件下,分别选择系统中部件1的故障次数N和总工作时间T为更换策略,利用更新过程和几何过程理论,选择最优的策略N*和T*,使得系统经长期运行单位时间内平均停机时间最短,并推导出了系统经长期运行单位时间内平均停机时间的表达式。
3.
by using the geometric process,The problem is to determine the optimal replacement policy such that the long―run expected downtime per unit time is minimal.
文章研究了单部件可修系统的最优维修更换问题,假定系统不能“修复如新”,分别以(1)系统的故障次数N;(2)系统的工作时间T;(3)二元函数(N,T)为策略,利用几何过程确定最优的策略,使得系统经长期运行单位时间内平均停机时间达到最少,并求出了系统经长期运行单位时间内平均停机时间的明显表达式,对故障系统的维修和更换具有参考价值和指导意义。
补充资料：停歇
1.休息。 2.停止……工作。犹言辞退。 3.停止;停息。 4.歇业。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条