1)  water of constitution
组成水
2)  water of composition
组成水
3)  essential water
组成水
4)  essential practice
组成水分
5)  nonessential water
非组成水(分)
6)  composition
组成
1.
Comparison of PCBs and PBDEs concentrations and compositions in the Guangzhou atmosphere in summer;
广州市夏季大气中多氯联苯和多溴联苯醚的含量及组成对比
2.
Study on the extraction,separation and composition of peach gum polysaccharide;
桃胶多糖的提取分离及组成性质研究
3.
Chemical composition-property relation of jet fuels;
喷气燃料的化学组成与理化性质的定量关系研究
7)  component
组成
1.
Studies on the component and stability of green pigment of gingko leaves;
银杏叶中绿色素的组成及稳定性研究
2.
Study on major components and liberation characteristics of discarded printed circuit board;
废旧电路板的组成与解离特性研究
3.
The contents and components of polyamines in plant-source foods;
植物源食品多胺含量与组成
8)  components
组成
1.
Because of complex components,the effects of C9 cuts to petroleum resin are unclear.
C9馏分由于成分组成相当复杂,其各成分对合成石油树脂影响的了解还十分有限。
2.
These components have been characterized by spectroscopic methods (FT-IR), namely acid number, basic nitrogen number, ultimate analysis and molecular weight measurements using vapor pressure.
之后对这些组分进行了元素、酸碱值、相对分子质量及红外光谱等组成结构测定。
3.
The experience of assembly(3 components)and shift of semi-mobile crushing plant in Qidashan Iron Ore Mine can be taken for reference in the case that new technology and new equipment of intermittent-continuous haulage system are adopted for achieving high economic profits.
齐大山铁矿矿石半移动破碎站的 3个组件组成和移设过程 ,为金属露天矿的间断 -连续运输工艺新技术的采用和新设备的利用提供了借鉴意见 ,以期获得最佳的经济效果。
9)  structure
组成
1.
The scale structure of coil rolled by CSP was investigated with SEM and XRD.
结果表明,轧后冷却过程对氧化皮的组成有显著影响,单张板的氧化皮组成为:Fe2O3∶Fe3O4∶FeO为6。
2.
XRD?IR?DTA?TG and Spectrophotometric analysis were used to research the composition and structure of the products.
用X 衍射、红外光谱、差热、热重、分光光度等方法对其组成和结构进行了研究。
3.
XRD, IR, DTA, TG and spectrophotometric analysis were used in the research of the composition and structure of the products.
用 X-衍射、红外光谱、差热、热重、分光光度等方法对其组成和结构进行了研究。
10)  constitution
组成
1.
Investigation on Constitution and Structure of theColored Mo(W) S Sn Cluster Compound Filmon Tin Surface;
锡表面Mo(W)-S-Sn彩色簇合物膜的组成与结构研究
2.
The structure and constitution of peritrophic membrane of Helicoverpa armigera:;
棉铃虫围食膜的结构和组成
3.
The main constitution of the coating is silica sol sodium silicate ethyl-silicate silica sol,sodium silicate,ethyl-silicate.
涂料的粘结剂主要由硅酸乙酯、硅溶胶、水玻璃等组成。
补充资料:茶叶水分检验


茶叶水分检验
moisture inspection of tea

  茶叶水分检验(moisture inspeetion oftea)茶叶检验之一。检侧成品茶中水分含量的技术措施。茶叶水分含t对品质变化起主要作用,水分检验列为国家对出口茶叶的重要检验项目之一。 1981年3月中华人民共和国对外贸易部和国家进出口商品检验局联合制订颁布的《茶叶WMB45一81》部哲行标准规定采用恒量法(103士2℃法)和快速法(120士2℃一小时法与130士2℃27分钟法)。其中恒量法与国际标准化组织150 1573方法相似。水分检验一般采用快速法,如发现检验结果有问题或执行仲裁检验时,必须用恒量法为最后依据。 103士2℃恒量法又称仲裁法。在已知重量的铝盒内,准确称取混匀试样10克(I 50规定取样约4克),然后将铝盒移入预热至103士2℃烘箱内,烘干四小时(150规定第一次为六小时)。加盖后取盒,置于干燥器内,冷却、称重。再移置同样温度的烘箱中烘干一小时,冷却、称重,如此重复操作,直至恒重,计算失水百分率。 120土2℃一小时法操作方法同上。称取试样10克,移入预热至120℃供箱内,温度回升至120oC时起算,保持一小时,取出冷却并称重,计算失水百分率。 130士2’C 27分钟法操作方法及用具同上。称取试样10克,移入预热至13《)’C烘箱内,温度回升至130’C时起算,烘干27分钟,取出,冷却称重,计算失水百分率。 日本茶叶水分检验有公定的98一100℃下干澡至恒量法,有为贮藏及包装试验的定量法,即在常压110℃下干燥5小时法。近年来研究使用FD一IB型红外线水分计的快速简便法,即采用一个185瓦灯泡固定在距试样3厘米的位置,根据茶叶水分多少,可在温度调节刻度5一6之间调节灯泡温度,只需20一25分钟就可取得精度较高的水分定量值。 茶叶中水分分结合水和游离水,水分活性与游离水有关。微生物在纯水或干操条件下都不能生存,茶叶中游离水不是纯水,故能寄生徽生物,侧定活性水分可预知茶叶发称点和非酶性揭变的变化规律,从而控制茶叶水分,保护茶叶品质。(英息琴)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条