1)  lighting angle
照明角度
2)  illumination
照明
1.
Application of optical fiber to medical illumination;
光纤在医学照明上的应用
2.
The design of laser fiber inducer attached two channels with the function of exhausting smoke and illumination;
一种带抽烟吸引及照明通道的激光光纤导引器的设计
3)  Lighting
照明
1.
Improvement on energy saving lighting of electrolytic copper smelter plant;
冶炼厂电解铜车间照明节能改造
2.
Lighting and Energy-Saving of the Ceramic Production Worskop;
陶瓷生产车间的照明与节能
4)  light
照明
1.
It is great to light energy-saving potentiality;
照明系统的节能潜力分析
2.
Combined with some relative regulations & design experiences in clean medicine workshop many years,it introduces briefly designs & concrete methods of power?light?fireproof and ground connection in clean medicine workshop and points out that electric design will be perfected gradually on the base of understanding regulations & renewing design ideas.
结合有关规范及多年药厂洁净车间的设计经验 ,对医药洁净厂房内的动力、照明、消防及接地等设计和具体做法作了简要论述 ,指出只有在对规范理解的基础上 ,以人为本 ,更新设计观念 ,才能使电气设计更趋完善。
5)  illumination and illuminating rate
照明度和照明率
6)  Lighting system
照明系统
1.
Emergency treatment to the lighting system of Shanxi stadium;
山西体育场照明系统应急处理
2.
Application of Configuration King to Lighting System of railway passenger stations;
组态王软件在客运照明系统中的应用
3.
Analysis and design of optical tunnel lighting system for liquid crystal projector;
液晶投影机光棒照明系统的分析与设计
参考词条
补充资料:Anglelapping角度研磨

angle lapping 的目的是为了测量junction的深度,所作的芯片前处理,这种采用光线干涉测量的方法就称之angle lapping。公式为xj=λ/2 nf即junction深度等于入射光波长的一半与干涉条纹数之乘积。但渐渐的随着vlsi组件的缩小,准确度及精密度都无法因应。如srp(spreading resistance prqbing)也是应用angle lapping的方法作前处理,采用的方法是以表面植入浓度与阻值的对应关系求出junction的深度,精确度远超过入射光干涉法。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。