1)  vinylfibre
乙烯基系纤维
2)  ethylene
乙烯
1.
The solvent effects on the complexing reaction of nickel dithiolene and ethylene;
溶剂对镍连二硫烯与乙烯反应的影响
2.
Modeling and analysis of oxidation reactor of ethylene coupled mass-transfer and reaction;
传质与反应耦合的乙烯氧化反应器模型与分析
3)  C_2H_4
乙烯
1.
C_2H_4 gas photocatalysis reaction activated by TiO_2 powder immobilized on glass pipe;
玻璃管载二氧化钛粉体对乙烯气体的光催化效应
2.
C_2H_4 removal by gas photocatalysis reaction of TiO_2 film coated on glass pipe;
管载二氧化钛凝胶镀膜光催化清除乙烯气体
4)  Ethene
乙烯
1.
Ethene Adsorption on Mordenite and Modified Mordenite;
乙烯在丝光沸石和改性丝光沸石孔道内的吸附行为
2.
Study on production of propylene and ethene from 1-butene by catalytic cracking;
1-丁烯催化裂解制丙烯和乙烯反应性能的研究
3.
Dimerization of Ethene Catalyzed by Acidic Zeolites;
酸性分子筛催化乙烯二聚反应
5)  C2H4
乙烯
1.
Low temperature at 0℃±1℃resulted in decrease of respiratory rate and C2H4 production significantly, and retained good quality of fruits for a longer storage period.
0℃低温显著延缓呼吸峰和乙烯峰的出现,保持果实品质。
2.
Experimental results showed that the activity of n-C4 and yield of alkene, especially C2H4, over acidic zeolites were higher than that of Basic zeolites.
发现酸性Pentasil型沸石的蒸汽热裂反应活性高,烯烃特别是乙烯收率较高,其中以SiO2/Al2O3比为60的HZSM—5型沸石为最佳。
3.
The insulation structure, demand and method of design, selection of insulation material and testing results on physical properties of C2H4 tank are introduced.
本文简要介绍了乙烯公路槽车的绝热结构、设计要求与方法、绝热材料的选择和有关物性参数的试验结果。
6)  acetylene
乙烯
1.
Surface-enhanced Raman spectrum of acetylene and ethylene in the simple gas cell;
简易气体样品池中的乙炔和乙烯的表面增强拉曼光谱
2.
s:Hydrogenation of acetylene on 12% Ni/CNF?0.
考察了反应温度、n(H2)/n(C2H2)以及总空速对反应的影响,得到了在n(H2)/n(C2H2)较宽的范围内乙炔加氢为乙烯具有良好选择性的催化剂0。
3.
The effect on activity of catalyst,and the influences of temperature have been investigated in the two type of hydrosilylation,we found the reaction of cyclohexene with hydrogenc-cotaining chlorosilane must need the presence of oxygen,but the acetylene with hydrogen-containing chlorosilane can react without the presence of oxygen.
用同一种催化剂合成了含环己基有机硅化合物和含乙烯基有机硅化合和物 ,并比较了催化合成这两种类型的有机硅化合物对催化剂的活化方式、反应温度控制的不同 ,发现环状烯烃比链状烯烃在催化加成上有更高的要求。
参考词条
补充资料:四氟乙烯-全氟烷基乙烯基醚共聚纤维
分子式:
CAS号:

性质:指共聚有少量全氟烷基乙烯基醚的可熔聚四氟乙烯纤维。一般只作单丝,密度2.2g/cm3,强度1.46cN/dtex,伸长率9%-12%,沸水收缩率12%~15%。制法是将四氟乙烯和4.4%~7%(摩尔)的共聚单体进行游离基聚合,再将树脂在340~360℃熔纺和拉伸而得。用途主要作离子交换膜的补强织物和强度要求高的耐腐蚀材料。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。