1) coating by inorganic cementitious bonding
无机胶凝粘结涂层
2) Inorganic adhesive coating
无机胶粘涂层
3) inorganic binding material
无机粘结胶
1.
Performances of inorganic binding material and its application —an ideal material for remedying and reinforcing concrete works;
一种用于混凝土修补的无机粘结胶的性能及应用
4) adhesion coating
胶粘涂层
1.
According to the model of axial symmetry in semi unlimited body, the absorbing moisture stress of adhesion coating under water pressure is studied, which is caused by the difference of absorbing moisture property between filling particulate and adhesion coating basis.
根据半无限体的轴对称模型，对静水压下的胶粘涂层因填充粒子与胶层基体间吸湿性能的差别而引起的吸湿应力进行了研究，以达到饱和吸湿浓度的抗水力磨蚀胶粘涂层为例，对吸湿应力作了数值计算，并进行了结果分
2.
In this paper, the thermal stress between the resinous basis and filled panical in anti-abrasion adhesion coating is analysed, the results show that in the interface the thermal stress reaches the maximum value, and it is possible that too high temperature causes the plasticity of resinous basis and separating between basis and filled particles.
分析了耐磨胶粘涂层基体与填充微粒间的微观热应力。
5) Adhesive Coatings
胶粘涂层
1.
Study on the Slurry Erosion Wear. Properties of the Adhesive Coatings;
耐磨环氧胶粘涂层的浆体冲蚀磨损特性研究
2.
The wear properties of antiwear adhesive coatings under solid particle erosion and slurry erosion condition were studied in this paper.
本文对气固冲蚀和浆体冲蚀条件下耐磨环氧胶粘涂层的磨损特性进行了研究。
补充资料：Sds-聚丙烯酰胺凝胶电泳凝胶电泳
sds-聚丙烯酰胺凝胶电泳（sds-page，sodium dodecyl sulfate-polyacrylamide gel electrohoresis）
在有去污剂十二烷基硫酸钠存在下的聚丙烯酰胺凝胶电泳。sds-page只是按照分子大小分离的，而不是根据分子所带的电荷和大小分离的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条