1) microparticulate stationary phase
微粒固定相
2) regular microorganism particle
固定化微生物颗粒
1.
This paper analyses the absorbing balance equation and dynamics model of regular microorganism particle, which offers theoretical foundation for the regular bioreactor.
分析固定化微生物颗粒的吸附平衡方程和动力学模型,为固定化生物反应器的设计提供理论依据。
3) Solid particle
固体微粒
1.
The composition of solid particle and influence on interfacial tension between organic phase and water phase were investigated at different pH by using XRD and interfacial tension instrument.
为查清紫金山铜矿溶剂萃取铜过程界面乳化的原因,采用X射线衍射和界面张力等现代分析检测手段,考察了铜溶剂萃取过程中固体微粒的组成和来源以及不同pH值条件下不同种类的固体微粒对有机相-水相间界面张力的影响。
2.
The effects of solid particles on stability of interfacial emulsion in copper solvent extraction was studied.
对铜溶剂萃取时萃原液中固体微粒稳定界面乳化液的机理进行了研究。
3.
In order to investigate the influence of the solid particle on the zincous electrlbath's voltage and the quality and output of depositing zinc in zinc electrowinning,two different type of filters are introduced to carry out the filtration experiment of electrolysis mixture liquid.
指出悬浮在电解混合液中的固体微粒主要是钙和锶的不溶物、SiO2 及少量MnO2 。
4) solid particles
固体微粒
1.
For solid particles being the most deleterious matter in lubricating oils,the dielectrophoresis separation process system for removing the solid particles was established.
针对润滑油中危害最大物质之一的固体微粒,建立了润滑油介电动力学分离流态实验装置系统,研究了该方法主要工艺技术参数:电场强度和流速等。
2.
In order to avoid the formation of the third phase during the process of solvent extraction of copper,the composition of the solid particles in the third phase was examined by XRD as well as adsorption and degradation of the extractant caused by the solid particles were investigated by IR and GC-MS methods.
采用X射线衍射、傅立叶变换红外光谱、气-质联用色谱等分析检测手段研究了铜萃取过程中第三相固体微粒的组成、固体微粒对萃取剂的吸附和降解作用,寻求抑制铜萃取过程中第三相形成的方法。
5) solid particle
固相颗粒
1.
Study on the numerical simulation of the reservoir damage of the solid particle in injection water and its application;
注水井固相颗粒伤害数值模拟研究及应用
2.
The dynamic test and analysis of the drilling fluid solid particle post-treating unit
钻井液固相颗粒后处理装置的动态测试与分析
3.
This agent consists of HG modified resin, cross linking agent, and HS solid particles.
该高温暂堵剂由HG改性树脂、交联剂、HS固相颗粒组成。
6) solid particles
固相颗粒
1.
Through a simulating experiment the rock permeability damage was studied,which was caused by the solid particles from water injection in the rocks with different permeability.
通过模拟试验,在低渗透率和中高渗透率的岩样中,研究了注入水中的固相颗粒对岩样渗透率损害率的影响。
补充资料：固定化固定相开管柱
分子式：
CAS号：
性质：固定化固定相是：(1)固定相分子间进行共价交联；(2)固定相与毛细管内表面进行化学键合。主要固定化方法有原位加热缩合法、原位自由基诱导法等。通常涂渍方法制备的开管柱在升温使用中，不同程度发生固定液流失、液膜破裂等现象，而固定化固定相开管柱柱性能稳定，柱效高。
CAS号：
性质：固定化固定相是：(1)固定相分子间进行共价交联；(2)固定相与毛细管内表面进行化学键合。主要固定化方法有原位加热缩合法、原位自由基诱导法等。通常涂渍方法制备的开管柱在升温使用中，不同程度发生固定液流失、液膜破裂等现象，而固定化固定相开管柱柱性能稳定，柱效高。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条