1) disconnect signal
脱接信号
2) signal receive
信号接收
1.
A new teaching device based technology of satellite signal receive;
基于卫星信号接收参数的教学装置
2.
The design scheme includes signal generator and signal receiver.
该方案主要分为信号发生和信号接收两个部分,分别对测试系统的模拟前端和数字系统电路进行了设计。
3) signal grounding
信号接地
1.
The grounding of automatic instrument system includes mainly protective grounding,signal grounding,shield grounding,intrinsic safety system grounding,electrostatic grounding and lightening stroke-proof grounding.
自动化仪表系统的接地主要有保护接地、信号接地、屏蔽接地、本质安全型系统接地、防静电接地、防雷接地等,相关规范对各种接地的要求也不尽相同。
2.
Signal grounding in electromagnetic compatibility aims to solve signal disturbance,the four ways of signal grounding and decoupling methods of ground loop and subsystem are introduced,and takes the grounding system of electric fast transients immunity test as an example,the solutions to reduce and restrain the disturbance in ground loops are put forward.
电磁兼容信号接地是为解决信号干扰问题,介绍了信号接地的四种方式以及地环路和子系统去耦解决方法,以电快速瞬变脉冲群抗扰度试验的接地系统为例,论述了减小和抑制接地回路干扰的方法。
4) signal synthesization
信号复接
5) Signal connection
信号联接
6) received signals
接收信号
1.
Monte Carlo method is a classical method used to simulate the mutiplescattering lidar received signals, but its main disadvantage is that calculation time can become prohibitively long.
MonteCarlo方法模拟多次散射激光雷达接收信号是一种经典方法，但这种方法的最大缺点是计算时间很长。
2.
A simple proportional relationship is established between the higher scattering and the single scattering by analyzing each level scattering of the multiple backscattering lidar received signals.
通过对多次后向散射激光雷达接收信号的各级散射的分析，在高次散射接收信号与单次散射接收信号之间建立了一个简单的比例关系，即它们的比值与总衰减系数成比例；用蒙特卡罗方法对激光雷达接收信号进行了模拟。
补充资料：星接阻抗和三角接阻抗的变换
星接阻抗和三角接阻抗的变换
transformation between starc-onnected and delta-connected impedances
x ing]一e乙日kongl介e sonJ一00}Iez日伙ongde匕一。一〕huon星接阻抗和三角接阻抗的变换(t ransfor-mation betweenstar一eonneeted and delta-eonneeted imPedanees)接成星形的三个阻抗和接成三角形的三个阻抗互相替代的等效变换。它们之间的关系可用一组变换公式表示。按这组公式，用星接阻抗替换三角接阻抗或者反过来，不会影响稳态下电路其他部分的正弦电压和电流，常用于对称三相电路的分析和计算。 图1为三个阻抗21、Z:、23接成星形(又称丫形)。图2为三个阻抗Z小22。、Zal接成三角形(又称△形)。它们之间的变换公式如下:人23土图1星接阻抗图2三角接阻抗(1)将星形连接变换成三角形连接212一Z:+22+2 122及3一22+za十警(1)、|冬|矛231一23+21+2321(2)将三角形连接变换成星形连接z、-二一典乒兴-) 艺‘2士乙“3十乙31…_2 oqZI，}Z。一下万~一二-二二-汁 乙‘2士乙23十乙3‘1_Z。IZoq}艺q一二二一~二，二二--，-二二-~J 乙12十乙23十艺32夕(2) 当三个星接阻抗相等，即21一Z:一23一z丫、三个三角接阻抗相等即212一223一231一Z△时，变换公式是 Z二一32丫，Z丫一Z△/3
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条