1) test tube gelling times
试管胶凝时间
2) gel time
凝胶时间
1.
Quantity of accelerant affected to gel time of anchoring agent for resin bolt;
促进剂用量对树脂锚杆锚固剂凝胶时间的影响
2.
Factors influencing the gel time of DCPD-type unsaturated polyester resin for coatings;
影响涂料用DCPD型不饱和聚酯涂料凝胶时间的因素
3.
Influence of the temperature on the gel time of the capsules in rock bolting system;
温度对树脂锚杆锚固剂凝胶时间的影响
4) gelation time
胶凝时间
1.
The results showed that the gelation time decreased with the curing temperature increasing,and at the optimized curing temperature(160℃),the gelation time was 126s and the appa.
结果表明:钡酚醛树脂的胶凝时间随温度升高而缩短,在最佳固化温度(160℃)时的胶凝时间为126 s,固化反应的表观活化能为60。
2.
The effects to the gelation time of water, the temperature , the pH value, the concentration of crosslink have been studied.
研究了水质、交联剂浓度、pH值对凝肢体系胶凝时间的影响。
3.
The gelation time was used as a scale standard of stability of TiO.
以胶凝时间作为TiO2溶胶稳定性的衡量标准,研究了加水方式、Acac含量、加水量、溶剂量、HCl量、水解温度等对TiO2溶胶胶凝时间的影响,从中选取一种稳定的溶胶用于制膜研究。
5) gelation time
凝胶时间
1.
Factors affecting gelation time of crystal adhesive for decorations;
影响饰品用水晶胶凝胶时间的因素
2.
Effect of hydrotalcite on the gelation time of epoxy resin;
两类水滑石对环氧树脂体系凝胶时间的影响
3.
Study on the gelation time of spray polyurea elastomer;
喷涂聚脲弹性体的凝胶时间研究
6) gelling time
胶凝时间
1.
The effects of catalysts and temperature on gelling time in the sol-gel process of TEOS(tetraethyl orthosilicate) are studied,and the surface morphology of the silica films prepared on various substrates observed in the article.
采用溶胶-凝胶法,研究了催化剂和反应温度对正硅酸乙脂溶胶-凝胶过程中胶凝时间的影响,观察了不同基材上制得的SiO2薄膜的表面形貌。
补充资料：Sds-聚丙烯酰胺凝胶电泳凝胶电泳
sds-聚丙烯酰胺凝胶电泳（sds-page，sodium dodecyl sulfate-polyacrylamide gel electrohoresis）
在有去污剂十二烷基硫酸钠存在下的聚丙烯酰胺凝胶电泳。sds-page只是按照分子大小分离的，而不是根据分子所带的电荷和大小分离的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条