1)  solar drying,sun drying,drying in the sun
日晒干燥
2)  sunlight
日晒
1.
This paper analyses the influence on its mechanic properties of PBO-AS fiber by high temperature, chemical solvent and sunlight, and compared with the mechanic properties of aramid fiber.
着重分析了高温、化学试剂、日晒等对PBO AS纤维部分力学指标的影响 ,并与芳纶纤维部分力学性能加以比较 ,对其应用提出了相应的建
3)  light fastness
日晒牢度
1.
Research work and advances in relationship between light fastness of anthraquione dyes and its molecular structures in recent years were reviewed.
本文综述了蒽醌染料的日晒牢度与其结构的构效关系研究进展。
2.
The basic principle of photochemistry of dye is briefly presented,and the factors affecting light fastness of the fabrics with reactive dyes are analyzed from this and some improving measures are accordingly taken in order to be helpful with manufacture.
本文简要阐述了染料光化学褪色的基本原理,由此分析了影响活性染料染色织物日晒牢度各因素并提出了相应的改进措施,对实际生产具有一定的指导意义。
3.
In this paper passage treated the cotton fabric with surfactant,then dyeing with reactive lemon K-4G which in common dyeing process has low light fastness.
以表面活性剂对棉织物处理为例,用常规染色中日晒牢度较低的染料--活性嫩黄K-4G进行染色,与常规染色的棉布进行日晒牢度的比较后,摸索出了一种兼顾环保、节能的染色工艺。
4)  solar evaporation
日晒蒸发
1.
Through solar evaporation in 400 m~2 salt field in winter in Zabuye Salt Lake,the rule of composition evoltion of the brine is studied,and we explore and summarize the salt field operating situation and practical result of brine-preparation in winter.
　试验以西藏扎布耶盐湖冬季卤水为研究对象,在扎布耶盐湖现场400m2盐田上进行卤水冬季日晒蒸发试验,研究冬季日晒蒸发条件下盐田卤水的组成变化规律,摸索总结冬季盐田制卤操作情况和实际效果,为大规模开发扎布耶盐湖锂资源的盐田工程设计及制卤工艺操作提供必要的基础参数和依据。
5)  drying during daytime and collecting at night
日晒夜聚
6)  sunburn
日晒伤
1.
Clinical experience with MEBO in treating 248 cases of sunburn;
MEBO治疗海训“日晒伤”248例临床体会
2.
Clinical Analysis of Sunburn during Seaside Training in Southeast Coastland Troops of China and Primary Experimental Study on Its Mechanism of Apoptosis;
东南沿海某部濒海训练日晒伤临床分析及凋亡机制的初探
参考词条
补充资料：活性污泥干燥工艺及成套干燥设备
一、.工艺特点 该干燥工艺是针对高水份污泥(大于65%,小于85%)的干燥特点而设计的,干燥时,物料容易粘结成 团,因而采用搅拌气流干 燥机进行作业,搅拌气流干燥机采用强力打击剪切,破碎,抛撒的方式,将粘结而成的团块 破碎成微粒,增大物料与空气进行湿热交换的面积,使干燥有效地进行,提高干燥效率. 本工艺要求处理量大,物料终水份要求不高,因而采用二级搅拌气流干燥机串联作业以满足 干燥要求.配以直火式热风炉的热源,该热风炉热效率达90%以上,热风温度达900`C, 有条件时还可将锅炉尾气引入进一步降低能耗.
　该成套设备可用于造纸厂,制革厂,食品厂等活性污泥的干燥;酿造厂,豆制品厂. 淀粉加工厂等 渣物料的干燥;养鸡厂,养猪厂等粪便物料的干燥.
 
二、工作原理
　　物料由加料机加入搅拌干燥机后,受到同速转向相向的打板的打击,剪切,抛散,成 雾状弥漫于整个干燥器内,与热风炉进来的热空气进行强烈的湿热交换,强化干燥.由于打板的打击. 剪切,使物料难以粘结成团形成外焦内湿的小球,并使物料的表面和表面积不断地变化 ,从而顺利地进行干燥.当物料干燥到一定程度后,物料被气流夹带进入二级搅拌气流 干燥机中进行进一步干燥,最后由旋风分离器分离.
三,主要技术经济指标
　　 处理量: 6.25t/h       　　 物料初水份: <85%     　　 终水份: <40%
　　 水份蒸发量: 4.48T/H   　　 装机功率: 85KW       　　 煤耗: 700KG/小时
　　 占地面积: 10*20(M)    　　 操作人数: 7人
四,主要设备
　　 1. 加料机 2台    　　 2. 直热式热风炉 2台   　　 3. 搅拌气流干燥机 2台
　　 4.旋风分离器 2台      5. 引风机 1台   
说明：补充资料仅用于学习参考，请勿用于其它任何用途。