2) gas discharging lamps
气体发射灯
3) luminous radiation
发光[火焰]辐射,发光体辐射;发光气体辐射
4) Air operated launch
气动发射
5) gas jet
气体射流
1.
The methods and theories of cooling and lubrication with gas jet in metal cutting are discussed, and the present status of study on the green cutting technologies, in which the gas, such as air, nitrogen, carbon dioxide, water vapor and so on, is employed as coolant and lubricant,is introduced.
论述了金属切削加工过程中采用气体射流冷却润滑的方法和理论基础,介绍了用空气、氮气、二氧化碳气及水蒸汽等气体作冷却润滑剂的绿色切削技术的研究现状。
2.
Three upward gas jet nozzles were symmetrically installed at an angle of 45 degree on a certain position of the downer where the solids have been dispersed well.
192m的下行床中颗粒达到均匀分布的部位,沿床四周均布了三个45度方向逆流场气体射流入口,在此处设立气体入口可以使颗粒分散与气固快速接触不再同时进行。
3.
Computer modeling, as a means of studying the mixture formation in diesel engines, is used in the study of the development and wall impingement of an unsteady gas jet.
用计算机模拟方法研究了非稳态气体射流的发展及碰壁过程,作为了解柴油机喷雾混气形成过程的辅助手段。
6) gas radiation
气体辐射
1.
The gas radiation network units under the general gas radiative conditions is established,and the calculating formula of radiative heat exchange guantity between gas and aroud wall is derived by radiation network units and network analysis.
建立了一般气体辐射条件下气体辐射网络单元 ,并由此用网络分析法导出了气体与围壁间的辐射换热量计算公式 ,结果与传统法导出的完全一样。
2.
On the basis of the experiments,the behavior of gas radiation heat transfer versus engine load and speed was studied.
在一台直喷式柴油机上实测了气缸内辐射和火焰辐射热流量,在此基础上,研究了气缸内气体辐射传热及其随负荷和转速变化的规律,分析了气体辐射热流量占气缸内辐射热流量和总热流量的比例随负荷和转速变化的规律。
3.
In order to compare the accuracy of box model with that of gray band approximation of spectral band models, a typical one-dimensional gas radiation problem was analyzed using discrete ordinate method.
在总结现有计算非灰气体辐射特性的各种模型与方法的基础上 ,利用箱带模型与离散坐标法 (DOM)相结合的方法计算了一维无限大平行平板间气体介质在均匀型、边界层型及抛物型三种温度分布下的辐射换热。
补充资料:导弹机动发射(见导弹发射方式)
导弹机动发射(见导弹发射方式)
maneuverable launching of missile
算薰;笙簌巍骂 able launching 式。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条