1) intercostal member
品间腐蚀
2) intergranular corrosion test
品间腐蚀试验
3) intergranular corrosion
晶间腐蚀
1.
Test and analysis of intergranular corrosion for stainless steel surfacing strip;
不锈钢焊带晶间腐蚀试验分析
2.
Influence of quench rate and zirconium content on intergranular corrosion of 7055 type aluminum alloy;
淬火速率和锆含量对7055型铝合金晶间腐蚀的影响
3.
Effevt of V on intergranular corrosion resistance of austenite weld metal;
元素V对奥氏体焊缝金属晶间腐蚀敏感性的影响
4) intercrystalline corrosion
晶间腐蚀
1.
Effects of aging treatment on intercrystalline corrosion and exfoliation corrosion behavior of 7A52 aluminum alloy;
时效工艺对7A52铝合金晶间腐蚀和剥蚀行为的影响
2.
Study of Anti-intercrystalline corrosion performance for welded joint of stainless steel sheet used for urban rail passenger car;
城轨车用不锈钢薄板焊接接头抗晶间腐蚀性能的试验研究
3.
The microstructure after heat treatment was observed,the content of ferrite was measured(<40%),and the hardness measurement,pitting corrosion and intercrystalline corrosion test were also conducted.
对热处理后的组织进行了金相观察,测定铁素体体积百分含量低于40%,并进行硬度测量、点腐蚀以及晶间腐蚀试验。
5) intergranular attack
晶间腐蚀
1.
The sensitization to intergranular attack(IGA) of Fe-17Mn-13Cr-0.
3N奥氏体不锈钢的耐晶间腐蚀的程度。
2.
The susceptibility to intergranular attack(IGA) of austenitic stainless steel were studied by electrochemical potentiokinetic reactivation(EPR).
利用电化学动电位再活化(即EPR)法检测了奥氏体不锈钢晶间腐蚀敏感性的程度。
3.
is the working temperature of the sodium loop, the intergranular attack property of the materials should be considered in structure material selection.
研究表明:316不锈钢在此环境下,由于敏化所造成的晶间腐蚀不可避免,而316Ti和316L不锈钢的抗晶间腐蚀性能优于316不锈钢。
6) crystal corrosion
晶间腐蚀
1.
the condition and mechanism of the occurrence of crystal corrosion and local corrosion were stated.
针对在化工行业中局部腐蚀的危险性 ,本文着重介绍了局部腐蚀中的晶间腐蚀和应力腐蚀发生的条件、机理以及防范的措
补充资料：腐蚀品
系指能灼伤人体组织并对金属等物品造成损坏的固体或液体。与皮肤接触在4小时内出现可见坏死现象，或温度在55℃时，对20号钢的表面均匀年腐蚀率超过6.25毫米／年（mm／年）的固体或液体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条