1) neptometer
棉结测试仪
2) cotton neps
棉结
1.
By the expeciments, it was obtioned the ralations between quality index of raw cotton and the cotton neps of finished yarn.
本文通过实验得出原棉的各项指标与成纱棉结的关系,要想降低成纱棉结、提高成纱质量。
2.
However,the installation has no active effectiveness in removing cotton neps in case of removing the suction system of the taker-in rollers.
在A186型梳棉机后罩板处加装了一组特殊吸风装置,用常规方法和AFis法分别对所生产的生条进行检测,结果表明,加装该装置后生条中短绒数量有所减少,通过对特殊吸风装置吸走废物分析证实,废物中短绒占80%左右,生条中杂质数量比单独加固定盖板也有所减少(在去掉刺辊吸风的条件下),但该装置对棉结去除无正面影响。
3.
An Approach is done into the forming of cotton neps and reduction thereof.
对棉结的形成原因、减少途径进行了分析研究 ,指出了棉结形成的主要原因和减少棉结的主要途径 ,总结了棉结的检测方法与变化情况 ,提出了一些见
3) neps
棉结
1.
Commence on fibers ‘five degree’, introduce ways to reduce neps simply;
从纤维“五度”着手浅谈棉结降低方法
2.
The study of neps in spinning process;
纺纱生产中棉结问题的研究
3.
Production practice of reducing fine-count polyester blended yarn's neps and thickness;
降低细旦涤纶混纺纱棉结和粗节的生产实践
4) Nep
棉结
1.
Investigation on the neps producing rule during processing combed yarns with rotor spinner;
转杯纺精梳纱棉结产生规律探讨
2.
Controlling of Neps and Impurities in Opening and Carding;
清梳工序棉结杂质的控制
5) combed cotton knot
精梳棉结
6) spun yarn cotton knot
细纱棉结
1.
On the basis of the actual production data in a spinning business enterprise in XinJiang,the article analyzed the dependency relation of combed cotton knot and spun yarn cotton knot,discussed the reasons which produced the combed cotton knot,gave some measures and methods of controlling the foreign substances of combed cotton knot and improving the quality of combed yarn.
基于新疆某纺织企业的实际生产数据,分析了精梳条棉结与细纱棉结的相关关系,探讨了精梳工序棉结产生的原因,提出了控制精梳条棉结杂质,提高精梳纱质量的一些措施和方法。
参考词条
生条棉结
棉结数
棉结指数
去除棉结
石棉结构
棉结和短绒
带籽屑棉结
棉结计数器
棉结检验机
棉结仪等级
棉结纤维测试仪
带籽屑棉结(SCN)
带籽屑棉结直径
棉网棉结计数器
动态承诺
2-甲基-2-丙烯酸丁酯与2-丙烯酸丁酯、2-甲基-2-丙烯酸甲酯和2-丙烯酸的聚合物
补充资料:测试结果可接受性的检查和最终测试结果的确定
测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result
C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
说明:补充资料仅用于学习参考,请勿用于其它任何用途。